It will be plenty of light.
Eaton, is there a visual reference, manual, or diagram I can look at. I have pulled it about an inch down from the ceiling and I don't see any clips. Does the manufacturer have a direct contact?
This is the trim that attaches to the recessed housing. With the 3" Halo recessed housing (H36ICAT or H38ICAT) it's rated for a 120V GU10 50W lamp. With the Halo H38LVICAT 3" low-voltage housing, it's rated for a 12V MR16 50W lamp. Lumen output will vary by lamp manufacturer.
No, this is not dimmable.
Dear valued consumer, this is a wet location rated trim and can be used in this type of application. Please refer to the spec sheet under the "info & guides" sections for max lamp recommendations. Anything lamp wattage at max and below will work.
This is just a trim. Kelvin rating depends on the lamp you are going to use in the housing
I purchased 120v MR16 frosted flood reflector with GU10 base.