Genesis 30 in. x 31 in. Stainless Steel Backsplash

It's great. Easy to install. Measurements were perfect.

Easy to install. The only issue I had was relocating my electrical out let to accommodate the length of the backsplash. Easy fix using a retro fit outlet box perched at Home Depot.

Installed easily as instructed. Looks amazing and professional.

It’s a raised panel (1/4”) to allow for backsplash tile. The trim piece does not accommodate all ranges.

PROS: The metal is quality and looks nice. It is close enough to our range hood that you can't see a difference unless you really look closely. CONS: 1) Ours was made a bit out of square so there is a small gap at the top corner on one side that decreases as you move across the backplash and the top left corner is wider than the range hood by a small amount. 2) Ours was also made with a slight bend in it across the middle. Since the sides are rolled for strength, that causes the top corners to pull away from the wall. More on this below... 3) It mounts on a piece of styrofoam. This compounds the issue of the bend mentioned above because the foam and the foam adhesive are not strong enough to keep the top corners in place, and, because our walls are finished, we can't screw blocks in to the wall to attach a board to push it against the wall while the adhesive sets. Adding nails or screws at the bottom to hold it up does not solve the issue, it just helps prevent sagging of the backsplash while the adhesive sets. 4) Using styrofoam also means a lot of people will use the wrong type of adhesive and burn through the foam, causing the mounting system to fail. (you could potentially remedy this by using plywood to mount to the wall and attaching the PL Premium or something. That is what we are going to try next to hope it will grab stronger and prevent the corners from pulling out) I contacted the manufacturer about these issues and after about 2 weeks they finally responded and said I should just return it and get a new one. It would have been nice to have been offered a credit or something to compensate my time and screwing around to make it work.

It looks nice now that its up but I found it odd that it has a separate foam panel that screws to wall and then you glue panel to the foam. I hope I never have to take it down. And one corner didn't stick as well to wall...not sure if screw pulled through foam so we had a to find a way to correct it without removing it because it was glued. There must be a better way especially for the price.

Great backsplash! It was a perfect fit behind my new range which doesn’t have a “backsplash” back. There are several things which are good to know before installing the backsplash: * Measure the space where it will go to make sure that it will fit - mine did fit with 0.5 mm to spare at the top! * The backsplash is glued with a silicone adhesive, which is not included. The Genesis model needs approx. 150 ml/6 oz to attach both the panel and the backsplash. * The panel is styrofoam and not wood as specified in the linked installation instructions.

The instructions come with a QR code to a link for YouTube. Pretty easy to follow after that.

Easy to install, and give my kitchen a modern look.

Looks fantastic. Very easy installation with clear instructions.