28 in. x 80 in. Unfinished Flush Hardwood Interior Door Slab

Dear Valued Home Depot Customer, To better answer your question, please contact our HD.com customer service department at 800-430-3376 call any day between 6 a.m. and 2 a.m. EST, or call your local store, they can either answer your question or transfer you to your local store to answer your specific question.

JELD-WEN may be able to provide a custom order for the Unfinished Flush Hardwood Interior Door Slab in the size you are looking for. Please contact your local Lowe's store for ordering and availability in your area. Thank you for your inquiry.

Depends.. compression, bending, torsion, tension ?? If you put it horizontally between 2 full width sawhorses, likely several hundred pounds, if distributed evenly. Its hollow core, so not much impact or crush ability.

Yes, the JELD-WEN 28 in. x 80 in. Unfinished Flush Hardwood Interior Door Slab is available at a 24" width. Please see your local Home Depot store for ordering and availability. Thank you for allowing us to assist you today.

You are asking a question not associated with the Jeld-wen Unfinished Hardwood Interior door slab. I think this is a hollow core door that replaces the entire door, as I did with a few doors in my house. Probably why they sent me the question. Have not heard about 'skins' to replace door facades. They may have them as veneers and they'd need to be contact cemented on, but it will never look as good as a new door. They sound like old beat up doors if they are plasticy and need to have the skin replaced. Don't know if they are solid or hollow core, but you cant really take the skins off hollow core. Just add to it. That 'may' make the door too thick for the door jamb with new 'skins' on either side too. You'd need to alter the hinges and handle catch. Sounds like new hollow core doors would be your best option to keep the price down and have spiffy new doors that can be consistent throughout the house. Solid doors are expensive.

These doors are always 1/2 lesser than what it says. Your installer has to know how to place the hinge so it fit right.

Yes, it can be paint what and it could be easy to put the door nob hole in.

NO NOT OAK . MIGHT BE BIRCH. BREMMA HAS NO CLUE

Yes it can. I hung two of them. Just remember that it is hollow except for about 2 inch around the outside edges, side and ends. Be careful tightening the cross bolts in the hollow area. Just snug. The door is light so the one bolt you put thru the edge can hold all the weight.

Nothing, this is a hollow door made from cartoon....