IBC 454 MV 4-Light T5 White High Output Fluorescent High Bay

I have a 20 X 20 garage with 12’ ceilings, and 2 of these fixtures make it look like daylight! I suspended them about 12” from the ceiling. They do put out some heat. The housing itself is a bit flimsy, but it is to be expected based on the intended use of these lights. Instructions are not so great, but I was still able to wire them pretty easily.

Very bright. This light turns night into daylight.

Bought 2 of the 4 bulb fixtures for a new hig bay shop 16x 36 X 16h. The lighting looks about right and seem to do a good job. The fixture does need more than what's in the box. First you need 4 bulbs per unit at $10 each Then there is no hanging chains included but you have to hang it to avoid over heating if you flush mount. So be sure to get the hanging kit $4, they recommend 18" from the ceiling! Not practical unless you have an open ceiling with exposed frames or rafters. Mine had to be dry walled by the Twps. regs. So I just used the wire hangers on steel hooks. It's 4" from ceiling , should be decent cooling clearance. There is no wiring/plug to connect to the power so whether you are hard wiring or plugging in you need to add that. I used the end of 2 new extension cords with nice molded on plugs. If my stuff was not in storage I could have used old wire and plugs off retired appliances or computers. The wiring diagram looks a little tricky as it talks about setting up using only 2 or 3 bulbs? Fortunately it has a note on the fixture that it's pre wired for all 4 on, so hook up is easy. Remember to use a cord restraint as reqd. Pack of 10 another $5 . If you did try to surface mount you would find it not set up for easy disassembly and mounting. Use the hangers. Also I found the upper and lower main metal sections had nothing holding then together and we're coming apart in the middle so I added a cable tie around the entire fixture in the center.( behind the reflector). Before I hung the fixture I tested on the bench then left the cardboard packaging ends on to protect the bulb ends as I did not want to put the bulbs in 16' in the air. ( bulbs are only 5/8 dia and $10 each!) Overall good fixtures but with all the extras and bulbs nearer $150 each. LEDs are a good bit more but closer than you think as price includes bulbs and hangers for LEDs. Decided to go with new fixtures as without a lift, bulb replacement or repairs would be a real chore.

All these lights were damaged when the electrician removed them from the boxes.

I bought this light because it is very bright and would illuminate my pool table very well. The light is perfect for this. I purchased the wood from HomeDepot and assembled a very nice looking light for my pool table.

Bought 13 of these for a 30 by 80 shop low profile and super bright. in stock at home depot. i used the high output bulbs @ 10 a pop and it basically makes it daylight in there at night. easy to install for my application. as the trusses ar 4' apart. I mounted to the bottom of the metal trusses and have about 3' clearance overhead.

4-Light T5 White High Output Fluorescent High Bay works great in my shop 80 feet x 50 feet x 14.5 tall. I have 13 of them in the shop and have no dark spots. 10 of them would have been all that was needed. I would use them in any shop or any place that need Fluorescent lighting.

Puts out a lot of light. My garage isn't really a high bay, but these lights still really do the job well. As the others have said, the wiring instructions leave a little to be desired. Colored wires and black ink pictures don't mix. But I still got it figured out. Google is your friend. The T-5 bulbs are sold separate, they go for about 10 bucks at HD. Nice bright white light, which is what I like in the garage. Can be wired for 120 to 240 volts. Another nice feature is being able to muti-switch the lights. Turning on 2 or 4.

These fixtures are 4 bulb T5 extremely bright and energy efficient to boot. I installed these in my building that is 40x64 with 14' ceilings I installed 8 of these and am very well pleased. I love that they can be switched to burn 2 or 4 bulbs. This feature should come in handy a lot. These are not a flush mount. You have to hang them. But that was ok with me Like you I read the reviews ppl had wrote before I bought You will be very happy with these fixtures Thx. Mike

I am in the midst of replacing 8' T-!2 fixtures. Went to Home Depot and found these fixtures producing most of the light in the lighting aisle. Bought 2 to try. These output at least 4x the light of the T12 lamps. I have replaced all the fixtures above 12' with these. I'm sold on T5 technology. These are a little pricey, HD has the best price, but well worth the expense. These come preassembled. And these need to hang.