Hi T1000, The Safety Data Sheet (SDS) is viewable from this webpage, under the Info and Guides section, above.
Yes, The Loctite Power Grab All Purpose adhesive is compatible with standard XPS insulation as long as it is not filmed-faced insulation board otherwise the adhesive will not bond.
Thank you for the question. The Loctite Power Grab All Purpose Adhesive is a latex, water-based product that requires at least one bonding surface to be porous. Depending upon the paint that was used you more than likely will need to sand or rough the surfaces before using to improve adhesion development.
I used this to install ceiling tiles. It has not changed color or turned yellow or faded out and it is still holding perfectly. I cannot, however, answer the "exposure to sunlight" part of your question as mine was an indoor application.
Thank you for the question. The Loctite Power Grab Express All Purpose Construction Adhesive is a latex, water-based product and may not be suitable for all ceiling tile applications. This adhesive does require at least one bonding surface to be porous. If this is not the case, the adhesive will not work or bond. The success and actual quantity of adhesive needed will depend upon several factors. Type of ceiling tile being installed, type and condition of the ceiling surfaces, and specific ceiling tile manufacturer’s instructions and type of adhesive product recommendations. Approximately 1 tube per 8 square feet may be needed however this calculation may vary so you need to follow the specific ceiling manufacturer’s instructions.
Thank you for the question. The answer is no, the Loctite Power Grab Express All-Purpose is not designed for this type of application and should not be used for safety reasons in a shower setting. There is not enough information provided about the material composition or what was previously used to give an adequate answer. You should consult the manufacturer of the Corner shower shelf for proper installation instructions for the situation just described.
Thank you for the question. The answer is no, the Loctite Power Grab Express All-Purpose cannot be used for this application. This is a latex, water-based product and will not bond two non-porous substrates together. You should consult the manufacturer of the Corner shower Shelf for proper installation instructions of their product.
Thank you for the question. The Loctite Power Grab Express All Purpose Construction is not suitable for the application described and would not be recommended. This product is an interior use product., but more important it would not be recommended in areas where high heat may be generated for safety reasons. For te application you have described a thin-set mortar type product is what should be used.
Yes, this is a latex, water-based product.
The Loctite Power Grab Express All-Purpose Adhesive in a 1-gallon pail is not suitable for exterior applications. A trowel is the recommended method of application, for FRP Panels trowel dimensions are: 3/16” x ¼” v-shaped notches, flat top, spaced ½” apart.