Mine is about 1 1/2 years old and it is made in China.
This stand is made for Milwaukee , I dought it will work with any other brand
My husband hasn't even taken it out of the box!
This stand is made exclusively for the Milwaukee saw. The saw clips into the stand holding it stable. Other compact saws will not fit this stand.
hi ron I have this and it folds together if it is put together correctly the spacer bushings need to be installed where they cross and the inside/rear saw locks will close in front side I cant send picture because my saw/stand is in n.h and I am in ma.
I had the same issue. Just push it on really hard. After I did that, it was super stable. Great simple stand. But yes, I had to push really hard to get the pad to lock onto the leg.
No, this stand is designed specifically for the Milwaukee table saw. I don't believe the Flexvolt saw would fit and clamp onto the stand.
stand is 22 inches high fully opened and 34 inches high to top of table saw
As far as I know Milwaukee does not make a rolling stand for this saw. The stand that they do make is very sturdy and is easily leveled and even if you had a stand with locking casters on it, it would be hard to keep the stand from moving while you are trying to feed stock thru the saw. The saw is light enough that if you need to move it, just pick it up and move.