1.5 in. x 8-3/4 in. Branch Tailpiece Plastic Slip Joint

There are two methods of installing this. One is via 'Slip Joint Connection'. The other is via 'Direct Connection'. If you do it via 'Direct Connection' you need to buy the 'H' Flange Washer separately because it is not included. That part is #1000 050 069 - 1 1/2" Oatey Washers. Another # is HDC7195C.

I ordered this dishwasher branch tailpiece when I was replacing my sink. It was easy to connect to the sink and dishwasher drain tube. I had to cut the branch down so it wasn’t so long and then attach a plumbing clip just to make sure the dishwasher drain tube stayed securely in place. This branch tailpiece came with a few extra size adjusting washers and screw on cap things so you can transition to/from 1/2 to 3/4. If you need a d/w branch tailpiece I would recommend you take a look at this one.

So, in the picture it looks like the standard dishwasher tail piece that has a slip joint nut that points upward - which is normal. However, that design isn't ideal as that nut cannot be replaced and they are a booger to connect a plastic nut to a metal basket strainer. THIS is a much better design in that it has a small tailpiece that fits into the dishwasher leg. This is how it should be done.

This this is the perfect tailpiece for your dishwasher hookup. Nice quality and comes complete with everything you need to hook up your dishwasher to your drain line. Just remove your old tailpiece and put this one into place also can be cut to length. Hook up your dishwasher drain hose and clamp to the stem sticking out and your job is done. Simple and easy to install.

Just what I needed. Thanks

Have not installed as of yet

used these a lot. simple & works …