125-Watt Equivalent Integrated Outdoor LED Area Light and Flood Light, 1900 Lumens Outdoor Security Lighting (2-Pack)

This light was very easy to install I mounted it directly over my junction box on the light I was changing out in my hay shed. The fact that it is completely enclosed is a great feature for me! It’s dusty and dirty in a barn and I have comfort knowing it can’t get inside to the bulb. It’s fully waterproof for outdoor installation as well. It doesn’t get hot because of the LED bulb which is wonderful! The brightness definitely surprised me as well, much brighter then the light I replaced. Would definitely buy more of these lights!

HEAVY DUTY! Easy enough to install on a ceiling or a wall in about 20 - 30 minutes for anyone who has a current light fixture in place already. The base is solid and has only two screws to attach it to the surface. When you attach it, the feeling is 100% solid. If you have a commercial job that needs to be installed with conduit it has multiple thread locations so it can be part of a string, end of line or any application spot.

I was looking for a light for the passageway from my Bilco to my basement. It has a low ceiling, stacked stone walls and gets damp after a heavy rain. I find Tradesman want to get through it as quickly as possible. I wanted a light I could mount to the ceiling, could handle being run into and was impervious to moisture ... this is perfect! The aluminum construction is industrial quality. Everything screws together tightly, and there are gaskets to seal the threading. The light is a LED COB (see pic). The LED is rated for 50,000 hours, and based on my using it a few hours a week, should outlast me. For a fixture, LED bulb and junction box all-in-one ... it is a pretty good deal.

Rating provided by a verified purchaser

Beautiful piece, heavy duty, ready to install out the box! :)

Installed with Defiant dusk/dawn sensor (not included). The pro-bright does a good job. Eliminates the dark area. Low electricity cost. I found it more convenient to mount to a 'Polycase aluminum box' (7 X 7 X 2 5/8 approx-purchased elsewhere, drilling alteration required) based on my application whereby the pro-bright mounted to an existing 1" galvanized pipe flange extending from the wall at the corner of a barn,13 feet up. (Mounting at the corner, illuminates two sides of the barn). The sealed pro-bright and polycase box also assures no insects enter, plus, much of the pre-assembly was completed on the ground. Replaces 'old style yard light' because it wasn't working (hornets built a nest in it and this messed with the internals). I rented a scissor lift for safety. Would prefer a pro-bright unit with a screw in bulb. Nothing's easy, but, to me, seems easier and more economical to replace a bulb than an entire unit.

I've just installed the SAND BLAST GRAY OUTDOOR INTEGRATED LED VAPOR-TIGHT WALL PACK LIGHT. I could have done installation, but had to travel. My electrician says this a good product. I like that has a Vapor tight housing protects shields against dust, moisture and flammable vapor from entering into the fixture reducing risks of fire. Because there may be hazardous materials in the area. It's also Maintenance-free energy efficient LEDs with over 50,000-hour of life (equivalent to 23-year of life at 6-hour/day), eliminating your need to use and replace bulbs. So far I'm very pleased with the SAND BLAST GRAY OUTDOOR INTEGRATED LED VAPOR-TIGHT WALL PACK LIGHT. It provides more than enough light for a very dark location.

When I saw this fixture I knew the perfect application for it. Have been helping a friend of mine work on getting his cabin together which is on a mountain top where it is inaccessible 8 months out of the year and 20 feet of snow is the norm. He needed an vapor-tight fixture due to condensation issues when the snow is melting from that side of the cabin and unfortunately his electrical inspector had required a fixture on that outside wall. The icing on the cake was it was an LED lamp which is perfect in his situation with using solar and battery packs. These lamps don't pull much current and are said to last for years. My friend is very happy with this wall pack so I will recommend to anyone in need of a fixture which will not allow moisture to get in. Thanks

The Probrite VaporPro LED Vapor Light is made in China of apparent cast aluminum. It is well made and designed for installation in areas where explosive gases may become present. It is also water tight and can be used in wet locations as well. It comes equipped with a junction box with the wires already installed through a rubber plug for wall mounting assuming that a junction box has been installed in the wall. If not, the rubber plug is readily removed with access to four other plugs for conduit or any other vapor proof connection. The supplied junction box plugs have a small gasket for vapor protection. The package states that it is UL approved. However the only place where the UL label is shown is within the junction box casting along with an outside affixed gold label. There is no supporting UL certification statement or any other supporting vapor statements contained within the otherwise excellent installation and care instructions. The light also comes equipped with an addition sealing gasket for sealing against an installed wall box junction, an Allen wrench in which to disassemble the light and some electrical terminal caps in which to connect electrical wires. It is rated for about 1400 Lumens or about 100 watts at 14 watt power draw with translucent glass globe on. For our installation, the lamp is installed in our garden house for task lighting around the pool’s pump and filter. It will be mostly exposed to water but the garden house is also a repository for the lawn mower, chipper vac, lawn trimmer, blower and gasoline. The install should have been easy but it was not. Since the supplied junction box was used to connect the wires, four screws had to be removed. Two were straight forward, but two needed the lamp to be disassembled if one does not have a 90 degree Phillips head driver. Since one was to be had, the install was a bit easier. The lamp’s junction box has two mounting bosses diagonally opposite each another. This in my estimation is the minimum. More desirable would be a three or four point mounting system for a more secure mount. Using two ¼” diameter screws held the lamp in place. Overall for a task light it worked out quite well providing more than enough light in which to perform filter maintenance and to check on secondary pump filter material. For ambient lighting, it appears that more lights would be required depending of course how light is required according to code. However, for industrial applications, the lack of UL and other certifications within the contained instruction booklet is of concern. Labels fall off and during a safety audit documentation is a key factor. It should not be any additional effort by the manufacturer to include this information within the instruction booklet. It was a surprise that this information was not there to begin with. Therefore for the homeowner, the ProBrite Vapor Lamp appears to be OK for most applications since the operating environment is not as hazardous when compared to industrial vapor exposures. This is the case where there maybe gasoline vapor exposure within the garden house, but not likely as compared to water exposure as in the case being located near a pool mechanical/electrical equipment. However because of minimal mounting points and the difficulty installing the lamp, the rating is bumped to three instead of 5. For industrial applications, would demand additional Certification credentials so as to be assured that lamp meets the applicable safety standards. Because of this, cannot recommend the lamp at this time.

This is a really nice enclosed LED light which means that there is no access to the ball but is sealed so it is can be used in a hazardous location vapors I installed it inside of my shed uses an accent light it works really great super easy access everything is there to wire hook up simply mounted to a box and you're done Ricelyte would recommend if anybody looking for something and that they need a has this location acceptable like