Its SKU number is 250770.
I know where your coming from, some times the web site will show only pallet quantity purchase. but that's not the case, you can buy any quantity you need.
I did the same. It was close enough, and leaves a much better look than the wall blocks alone. The Paver stones had a white (salt) deposit which needs to be cleaned off after completion.
I too had the same problem and tried pressure washing alone and it made little difference. What did work was spraying a light film of muriatic acid on the pavers then washing it off with my inexpensive pressure washer. I think just a garden hose would do the job too. The white residue I believe is cement leftover from the manufacturing process.
I used construction adhesive.
According to the Home Depot calculator for the 10.5” x 7” pavestone. You will need 135 pavestones to cover the 100 sq. feet. This would include an extra 10% to cover potential waste and breakage.
They are not rated for vehicular traffic.
The Pavestone leveling sand that Home Depot carries is good. Also, using a plate compactor with a pad to prevent scratching the surface is a good idea. Either that, or you can wet sand the surface. Thank you for your inquiry!
Try spraying a light film of muriatic acid and washing it off with a garden hose or pressure washer. This will remove the left-over cement from the casting process.
Thank you, this is very helpful.