Store SO SKU #
Level, Align, Space and Hold your tile in place for a professional looking tile installation
Lippage occurs when there are differences in height between the tiles causing an uneven tile surface
This clip and wedge leveling system is designed for quick installation
These clips are designed to hold tiles from underneath while still allowing the mortar to grip the tile
Reusable wedges lock into clips, holding the tile at an even height
LASH Pro Pliers quickly set the wedge into the clip without overtightening
Use this chart to determine the LASH amount needed based on room and tile size
Use 1/4 in. x 3/8 in. x 1/4 in. square notch or larger
Produces even 1/16 in. grout lines
For use with tile from 1/4 in. to 7/16 in.
Place LASH clip under the tile and into the mortar
Slide reusable LASH wedge into each clip
Tap to remove clips at break-off point
A: The QEP Lash leveling system is designed to be used with tile. It will not accommodate 1" thick brick. Customer Care
A: You don't need these for subway tile. It is light enough to stay on the wall. As for wanting a 1/16 grout line, when I put my subway tile up, it had a little bit of a edge on the sides. Someone referred to it as self-spacing. I just put them up and I have a nice, thin grout line.
A: The curved LASH clips are designed for installations of large format floor tiles while the flat LASH clips are designed for floor and wall installations where a thinner thinset bed in required. -Alexis, Customer Care
A: Yes they can. They make the job so much easier than the "spacers".
A: Yes, they can be used w/4"x12" tile.