13 in. 11 Amp Corded Electric Walk Behind Push Mower and 8 Amp Electric Jet Fan Blower

The description says 8 amps so your basic 15 amp outlet should work just fine.

The 3 prong electric plug is connected on a short lead to the motor; you have to purchase (or own) your own extension cord, and in the length you require to perform its use.

Actually the nozzle is slightly ovoid. 2-7/8" tall x 2-5/8" wide (inside measurements)

50 ft.

It has a two-prong plug and is double insulated. I think there are three levels, but I just use the highest level since I need to clear sprinkler heads and the green concrete "donuts" that protect some of the sprinkler heads.

There is a chart in one of the online documents, probably the user manual, that talks about extension cord length and gauge in relation to the size (amperage) of the motor. You should double check it yourself, but I believe that there is a dash in the column for this mower and 100 foot cords, meaning that 100 foot cords are not recommended and can cause voltage drop and overheating problems. If you do not have electrical outlets that would allow you to use a 50 foot cord to reach all of your lawn, you should consider getting the next size up mower.

This mower is not self-propelled. How well it can go up or down hills is pretty much up to you. That being said, it is very light, only about 25 pounds. So, it is not too heavy to manage. One thing to consider...if you are using the grasscatcher as most people probably would, when it is full, especially with wet grass, that will add a bunch of weight to the whole contraption. In fact, there is enough weight in a full grasscatcher to just about lift the front end of the mower off the ground. Solution: empty the grasscatcher often.

I only use mine once so far no problem encounter.

Nice product! Just little small for my big yard

Hi Tracy, We appreciate your interest in the RYOBI 13 in. 11 Amp Corded Electric Walk Behind Push Mower RYAC130. NOTE: When using the grass catcher, do not install the mulching plug. Disconnect power supply. Lift the rear discharge door. Lift the grass catcher by its handle and place under the rear discharge door so that the hooks on the grass catcher are seated onto the slots on the mower housing. Release the rear discharge door. Connect to power supply when you are ready to mow. For additional help, contact RYOBI Customer Support at 1-800-860-4050. Thanks for asking! - Eve