I don’t recall exactly as it’s been two years since I installed it. It was long enough to reach my controller which is about 6 feet away. You can call them and they will answer your questions.
You could splice into the wire that is already there.
It’s likely compatible with most controllers, including Toro. It’s just one circuit, no computer chips or anything to be incompatible. If your Toro controller supports a rain sensor, I think it would support this one
Yes it does!
I don’t know about an Intermatic but it works just fine with a Rainbird timer.
Yes, it will work with Rain Bird ESP-6TM.
It does not work with Model 1ZEHTMR, hose timer. It is designed to work with with all Rain Bird electronic irrigation controllers, as well as the competitive brands. Hope this helps!
I think there is 25 feet of wire but you can extend by using wire nuts and some more wire. The sensor is basically a make or break circuit and so I'm sure that you could run two units off it as long as they both have the same conditions. By that I mean that both units require a break in the circuit when there is rain.
I don’t see why it wouldn’t, you just have to remove the jumper connection, and it should work just fine. If all else fails YouTube it!
This product was created to be used with Rain Bird controllers.