Store SO SKU #
A: Yes, this would be covered under warranty. Please contact Rev-A-Shelf directly.
A: I don't remember any hinges there are screws that attach it to the cabinet door which hinges but yes we received 2 trays and hardware.
A: Yes, 2 trays and 2 sets of hinges.
A: Yes. I was able to use it in two different rooms.
A: I guess it depends on what the nature of the curve is, but this unit is meant to be mounted to a FLAT surface. Good luck with whatever you decide.
A: Most likely not since the tip out tray is flat and must lay flat on the door.
A: No this has a straight edge
A: You will actually have more than enough hardware. The kit comes with 4 hinges in cases for a spit front. Follow instructions carefully and the result is great.
A: As long as you have a framed cabinet with face frame...not euro frameless you should not need anything else.
A: All hardware included in REV-A-SHELF box. 2 sets of hinges ,2 polymer trays and good instructions. Ps will tilt forward. Doesn't pull out.
A: The hinges included will allow the slab to be pulled forward. You shouldn't need any more hardware.
A: these hinges connect the sink front to the cabinet so not sure what you're asking about "pull forward". the hinge set is all that's needed to connect the front slab of the sink base cabinet to the frame of the cabinet but they just allow the slab to tilt out, not pull out.
A: Yes, this will work. This kit comes with (2) 14": trays and (2) pair of hinges. If you have a single slab drawer/door front you will of course only need one pair of the included hinges.
A: No additional hardware will be needed, most cabinet fronts are flat on the inside. I have two of these under my kitchen sink behind the cabinet front.