FP Ultra Lite 2 in. x 2 ft. x 4 ft. Stucco Grey Foundation Panel

Yes, this panel can be used for deck skirting.

weed wacker goes right through the soft stucco covering and the underlying foam.

Can 4 x 8 x 1.5 inches in bulk be bought in the east Palo Store and be shipped to Portola Valley, California?

I was thinking of buying these panels and gluing them to plywood for strength then use pressure treated lumber to frame a base to anchor them to the ground.

They are definitely tough and durable.

These work great for mobile home skirting just as you suggested. They are also designed to withstand snow, we get our fair share here too.

A complete installation guide can be viewed via a link on the right-hand side of the product page in order to help you determine if this product will suit your project needs.

Clean cuts, used adhesive on the seems and they fit tight so there was hardly a seam. Some I had to add a little gray adhesive to after the installation. Nice quality product, easy to install.

For installing the product you must follow this instruction 1) Dig around the foundation to the desired depth(usually about 1 foot). 2) Attach (optional) J-Channel tightly to the bottom of the siding and around the windows. 3) Wire brush the foundation to make sure it is clean and that any loose particles are removed. 4) Panels can be cut from the back (foam) side using a utility knife and straight edge. 5) After cutting, snap the panel by applying pressure from the coated side of the panel (similar to snapping drywall). 6) Corner pieces are made by rasping panel edges with a coarse rasp or file. With the coated surface facing down on a firm surface, file the foam to form an angled corner piece. 7) Apply rigid foam construction adhesive such as PL 300 and/or Enerfoam liberally to the back of the panel. Run the glue vertically (for drainage) about every 6 inches. Press the panels firmly against the foundation & replace the dirt to help hold them in place while the adhesive sets. 8) If you're not using J-Channel it may help to apply pressure on the panel with a heavy object (wood, cinder block) until the adhesive sets. Fasteners such as Styro Tapits or Tapcon Screws can also be used below and/or above grade in conjunction with the adhesive. 9) Seams and corners can be caulked with any matching or clear colored caulk. Matching Stone aggregate can be hand seeded into caulked areas if desired. 10) For installation over a paved surface allow a gap of 1” between the bottom of the

Hi Dave, Yes, our foundation panels can be painted with an exterior grade acrylic or latex paint.