|Product Depth (in.)||3 in||Product Height (in.)||16.5 in|
|Product Width (in.)||8.3 in|
|Application||Bathroom Sink, Laundry/Utility||Color/Finish||Gray|
|Pack Size||1||Plumbing Part Type||Bath Drain Trap/Component|
|Manufacturer Warranty||5 Year Warranty|
A: Dear Customer - Thank you for contacting us. You could use a Flexible Reducing Coupling https://www.homedepot.com/p/Charlotte-Pipe-1-1-2-in-x-2-in-PVC-DWV-Hub-x-Hub-Increaser-Reducer-Coupling-PVC001020600HD/203391373.
A: Dear Customer - Thank you for contacting us. While this configuration is often utilized in kitchens, it's not recommended to directly connect to a floor pipe. It is recommended to use a 90° elbow that is already cemented to the drain pipe. This helps prevent water suction in the P-Trap, reducing the risk of a loss of the water seal. Should you have any other questions or comments, please feel free to contact us at firstname.lastname@example.org
A: Dear Customer - Thank you for contacting us. If you have a 1 1/4" sink tailpiece, only use the 1 1/4" washer on its own. The orange washer is designed for use with 1 1/2" tailpieces. Ensure that the blue washer is correctly installed with the conical side facing downward. Avoid using Teflon tape, glue, or silicone that could interfere with the seal between the washer and the tube or nut. It's a good practice to have the entire installation pre-aligned before securely tightening all the nuts. For additional guidance and visual illustrations, you can refer to the installation manual provided at the following link: https://www.snappytrap.com/_files/ugd/d49e2c_630c78a482d44826a8e58442df4df775.pdf Should you have any questions or comments, please feel free to contact us at email@example.com
A: Well you were right, I had installed it correctly, just had to use an Oatey compression washer instead of the blue washer that came with the kit. Not sure what was wrong with the included reduction washer but the Oatey washer has me sealed up.
A: Dear Customer - Thank you for contacting us. Yes, the wall drain coupling provided in the Snappy Trap kit should fit a 2 (1.9) inch OD pipe.