Granite Stone Coating 5 Gal. Flint Gray Satin Interior/Exterior Concrete Resurfacer and Sealer

Tackled a 1200 Sq/Ft multilevel patio and it turned out really nice. First and foremost preparation is key. To be really successful with this product you need to get down to concrete with no residual coatings. I rented both a scrapper and a grinder to accomplish this removing a rustoleum 10X coating product followed by a through power washing. Then filled all joints with sikaflex self leveling sealant along with other minor holes using sikaflex construction sealant. Also used some self leveling underlayment in a low area. If you have any, and i mean any holes, depressions, etc you will not get the coverage expected. Applied two coats of the primer via brush and 18 inch roller. The containers of primer had more than 5 gallons as did the sealer which resulted in extra product. The roller rock containers were right at 5 gallons. Difficult to apply thin enough coats with squeegee so i reverted to a pool trowel. Did get the expected coverage as the coats were as thin as i could get them. Some tips. You cannot apply this on surfaces with direct sunlight. You should thin the product the recommended amount with water. Mechanically mix bucket more than once while applying. Don't apply when surface temperature is over 80. Trowel versus squeegee. Its not easy but it looks wonderful when done and appears very durable.

Looks great. Lots of compliments. I used 25 gallons total for two coats on 600 square feet. I pressure washed, applied muriatic acid, pressure washed again, primed, applied the two coats, and then applied two coats of sealant. It’s only been two weeks, in mild Northwest weather. I can’t speak for it’s durability. The application was not as easy as painting, but not difficult. I used a rubber squeegee on a broomstick. The mixing took time, but I did it by hand. It helps to work in small sections and spray lightly with water if any of it starts to dry out before being fully spread. Thorough mixing is important.

You will under-estimate how much you need for coverage. I ordered 3X the recommended application and still was close to running out. Overall gives a nice look to garage floor and has a non-slip surface.

Product was very good but coverage was less than stated

I tried speadrock for fist time , follwed directions, kind of diffificult at first . got the hang of it , my backyard is beautiful. Will reccommend this product five stars , will be purchasing more for steps.

Rating provided by a verified purchaser

This product was nothing like described- would never use again not Recommend. I had to have tile pit over top. Do not buy

Tough time getting product!

The product doesn't cover as advertised. You will get about 80% of the advertised coverage. The opinion is based on application done by professionals. The color is lighter than advertised. The ability to have vehicles drive over is minimal as it is not forgiving. Cleaning it will not be easy if oil is spilled on it. Not really a solution for a driveway but may be better in the backyard patio where staining is not a concern. The application is tedious and preparation is important.

This product was highly recommended. WE applied it as directed - cleaned the floors, applied a coat of the recommended primer - applied this coating then applied 2 coats of sealant per manufacturers recommendations. This floor picks up every stain and every footprint - our floors look dirty all the time and there is definitely a foot path showing from the outside door to the inside door - it is non-slip which is what we were looking for but looks ugly!