The RC14552CPKA comes equipped with heavy duty brush blades which are capable of cutting brush up to 3” in diameter.
Height is adjusted by loosening 4 each 3/4" bolts and lifting (or lowering) the deck to one of the other height adjustment holes and re-tightening. This is not done from the seat of the vehicle pulling the mower. It is a two-man job.
Approximately 425 lbs
I have cut at a 30 degree angle horizontally on a hillside, and I've pulled it perpendicular up and over a hill with the same incline/decline. You just need to make sure that you have 4' of level ground at the top and bottom so you don't high center or prevent the machine from cutting to the proper height.
I believe the smallest cut is 44".
I ordered additional blades from Swisher. There was no problem getting them
It requires a 2" ball to pull but, it could be modified. I pull mine with a 400 cc Arctic Cat but my 25 hp garden tractor would pull it just fine