Motion Sensor Starter Kit Designed specifically for the Taco "On" Command systems. The operation is different than general motion sensors as it will pick up motion as an instant contact and then will go into a 4 minute time delay. The On Command system will pick up the contact, automatically activate and will automatically shut off when hot water arrives. If someone is in the area of the motion sensor for longer than 4 minutes, the sensor will again send a contact signal to the pump. The electronic mechanism in the pump will tell the signal hot water is already there and will not allow the pump to operate. Since it is hardwired to pump a receiver is not required.
12-Volt hard wired
For automatic motion detection start of "on" command pump
Since it is hardwired to pump a receiver is not required
You will need Adobe® Acrobat® Reader to view PDF documents. Download a free copy from the Adobe Web site.
Product Depth (in.)
Product Height (in.)
Product Width (in.)
Product Weight (lb.)
Recommended Pump Types
Motion Activated Switch
Warranty / Certifications
Questions & Answers
Typical questions asked about products:
Is the product durable?
Is the product easy to use?
What are the dimensions of the product?
out of 1 reviews
100% recommend this product
Showing 1-1 of 1 reviews
Jan 6, 2019
I love the product, but am having a problem setting it up so I can't give it the 5 stars I want t...
I love the product, but am having a problem setting it up so I can't give it the 5 stars I want to. The switch is very convenient and easy to install. I had the pump up and operating in about 10 minutes with fully automatic sensing. The only issue is that the electronics board inside mine is different than the included instructions so I cannot figure out how to get mine to stop cycling on every 8 minutes. It works perfectly for sensing movement in the bathroom to turn on. If the instructions matched so that mine worked as described this would be five stars all the way down. For now, I must give it a lower score until it works better.