Yup. Took about 10 seconds to install. Nut doesn't tighten down all the way on the threaded back, so it is loose. Will probably pick up a couple of washers to tighten it down. Works like a charm.
The gauge goes up to 700 degrees fahrenheit
Yes, I picked mine up in store.
The threaded base appears to be 7/16 inch. In my Webber grill it would have been better if the threaded base would have been 1/2 inch longer. Because the original gauge had a chrome collar on outside, which I had to remove for this unit to fit. Object [object,Object].
l. This is a general temperature gauge that will fit most units.
Hello Filly, Robert from Nexgrill here. Yes, this will fit the 720-0783E. Happy Grilling!!!-Nexgrill
I checked the meat with a meat thermometer and it matched the reading on the electronic gauge.
It is round and garbage
The gauge head must be placed outside of the grill. It is made of plastic and would melt if left inside. The cable attached it the gauge is long enough to route outside of the grill. I placed it on a small table next to the grill. The receiver can be left in the house so that you can monitor it without have to keep running out side. The temperature is displayed on both the sender and receiver units.
5/16th. Garbage. Do not buy.