Assist Bar and Step Kit for TimeCutter SS and MX

The instructions that come with the part say that some drilling may be required even on a Toro mower. If your mower has an open vertical area on the frame about 8 inches wide and 3 inches high to mount it, I do not see any reason it would not work for you.

The instructions that come with the part say that some drilling may be required. On my 4225, there were numerous holes at the attachment point. The only ones that lined up were the 2 toward the front - and they were smaller than the provided fasteners and needed to be enlarged. None of the holes matched the back 2, so they had to be drilled. This step attachment was obviously designed after some mowers were engineered, so drilling holes to mount it should be expected.

yes

Should work with new holes quite basic handle

The instructions that come with the part say that some drilling may be required. On my 4225, there were numerous holes at the attachment point. The only ones that lined up were the 2 toward the front - and they were smaller than the provided fasteners and needed to be enlarged. None of the holes matched the back 2, so they had to be drilled. This step attachment was obviously designed after some mowers were engineered, so drilling holes to mount it should be expected.

No, the item is not compatible with that model.

Holes match your 4225

Yes, I had the hardware store install it before delivery.

The base of the bar is welded to the step; the bar does telescope up and down. You use half-height for mowing and full-height for ingress/egress support. The mower's drive handles are not good for support; they move too much.

No, this will not work with TimeCutter SW3200 model # 74780.