Bathroom Sink Pop-Up Drain with Overflow in Matte Gold

A:  Thank you for your inquiry SydG. The VIGO pop-up drain model VG16002 has a threaded top that is 3" that goes into the sink's drain hole prior to the tailpiece being attached.

A:  Thank you for your inquiry Bear. The VIGO pop-up drain with overflow model VG16002 will work, as long as the drain hole is 1 3/4" diameter.

A:  Thank you for your inquiry Jacquie. No, the VIGO pop-up drain for sinks without an overflow is model VG07000CH,

A:  All of the washer are supposed to be used in the drain setup so do not get rid of it. You have to remove the rubber gasket, plastic washer and brass nut to install the pop-up part of the drain. There's another rubber gasket that sits just below the head of the drain, keep that one on when installing. The order is remove the parts I mentioned, slide the pop-up head into the drain hole (make sure the overflow opening in the drain pipe faces towards the overflow openings of the sink. Next slide the white rubber gasket first onto the drain pipe, then the plastic washer, then the brass nut and screw the nut so it fits snug and pushes the rubber gasket up into the drain hole. Lastly screw on the bottom drain pipe, p-trap, etc. To make sure the drain didn't leak, I still used plumber's putty around any portion that had a rubber gasket including the top pop-up head, just in case. I know the rubber gaskets are meant to prevent it leaking but if it does leak it would first be one of those two spots that have a rubber gasket. A tip for tightening the brass nut and to keep the overflow opening facing the appropriate direction is to use needle nose pliers and inside the pop-up drain pipe are three metal bars, use one hand to hold the pliers onto one of those three bars, and use the other hand to tighten the brass nut with c-clamp pliers or an adjustable wrench. By holding the pipe down with the needle nose pliers it will keep the pop-up drain still and not twist in another direction when tightening the brass nut. I hope this helps!

A:  Good morning Printerman, Thank you for contacting VIGO Industries. Please contact our product support team at 866-591-7792, option 2 and we will be happy to assist you.