Frustrated01, Yes, ground-contact pressure-treated lumber is treated to resist rot, fungal decay, and termite damage, making it a good choice for areas that touch soil or stay damp. While it significantly reduces the risk compared to untreated wood, it’s not 100% termite-proof, especially in constantly wet conditions.
Frustrated01, Yes, ground-contact pressure-treated lumber is treated to resist rot, fungal decay, and termite damage, making it a good choice for areas that touch soil or stay damp. While it significantly reduces the risk compared to untreated wood, it’s not 100% termite-proof, especially in constantly wet conditions.
Hi Rotboard, yes, this product may be used for your desired application.
Doug, A standard 2×4 does not measure a full 2 inches by 4 inches after milling. The actual size is about 1.5 inches thick by 3.5 inches wide, with the 8 feet referring to its length. This is normal for dimensional lumber and applies to pressure-treated boards as well.
Doug, A standard 2×4 does not measure a full 2 inches by 4 inches after milling. The actual size is about 1.5 inches thick by 3.5 inches wide, with the 8 feet referring to its length. This is normal for dimensional lumber and applies to pressure-treated boards as well.
Paul, This lumber will hold up well outdoors since it’s ground-contact pressure treated, so it can work for a picnic table. Just keep in mind that treated wood isn’t meant for direct food contact, so you’ll want to sand it well and apply a good outdoor finish or sealant. Also be sure to use hardware that’s compatible with treated lumber to prevent corrosion.
Hello giovanni, this product will measure 1.5" thick, 5.5" wide, and 20ft long.
Hi Masiga, yes, this product may be used to build a ramp.
Hi Scott, for further assistance with pricing, please reach out to your local Home Depot ProDesk.
Yes, you can use 2×6 ground-contact pressure-treated lumber for a deck floor over a pond, since it’s rated for harsher, damp environments. However, constant moisture can still lead to rot, warping, or fastener corrosion if not properly managed. Use stainless or hot-dipped galvanized fasteners, leave gaps for drainage and airflow, and seal all cut ends. With proper design and maintenance, it will serve as a durable decking option.
