Questions and Answers for Ekena Millwork 39 in.W x 23 3/8 in.H x 3/8 in.T Large Cameron Decorative Fretwork Wall Panels in Architectural Grade PVC

A:  Thank you for your recent inquiry with The Home Depot . There is a photo with exact dimensions of the pieces on Homedepot.com in the second frame on the left side of the product. You may click on each of those pictures to get a better detail of the item. We appreciate your business and look forward to serving you in the future

A:  Thanks for reaching out. The width of the trim is 1.95 inches. While we are unable to see any attached pictures via a question, so hopefully that answers it for you. Fretwork installs easily and hassle-free, instantly upgrading any accent wall, ceiling, and more. To view the installation guide, please visit: https://images.homedepot-static.com/catalog/pdfImages/32/32c35c02-7fde-4e47-8de5-cb9543c48c25.pdf

A:  The trim in room is 5” at base.

A:  How wide is the trim of the square and The X piece Please see photo attached

A:  Thanks for reaching out. Yes, these panels cut, trim, and install easily and hassle-free with general woodworking tools. They install with construction adhesive and small brad nails, making them simple to add for all levels of installers and instantly upgrading any modern accent wall, ceiling, cabinet, kitchen island, and more!

A:  Thanks for reaching out. Yes, these typically install well on textured drywall, as long as it offers a consistent surface so the panels can be installed flat against the substrate. Authentic PVC fretwork wall panels install easily and hassle-free with construction adhesive and small brad nails, instantly upgrading any wall, ceiling, cabinet, kitchen island, and more. Hope this helps!

A:  Thanks for reaching out. Each “Large Cameron Wall Panel” is 42-3/8” x 23-3/8” and covers 6.88 square feet. They are sold individually, so you can order the quantity needed for your project. We'd recommend measure the height and width of the space (you are wanting to cover) and then dividing by the square footage (6.88). The panels install, cut, and trim easily and hassle-free with general woodworking tools. Hope this helps!

A:  It’s actually two pieces for 20.

A:  Thanks for reaching out. Sure, these can be used in that application. Please make sure there is a water-tight seal between and around the panels to prevent water damage behind the panels and to the mounting surface. For best results, prime the product thoroughly to achieve a smooth, consistent, paint-ready surface. The carved areas may require additional prime coats. Once priming is finished, paint the product with a good quality, vinyl safe 100% acrylic latex paint. If painting the product a dark color, colors that have an LVR rating of 54 or lower, use paints with heat reflective characteristics specifically formulated for use on vinyl or PVC products.

A:  Thanks for reaching out. It is not necessary to caulk the edges of each piece, unless you are using them in a situation where water can get behind them (backsplash, shower, ect). In that application, we'd recommend making sure the gaps are properly sealed to prevent water from entering/sitting behind the back of the panels. The gaps should be sealed with paintable (if you plan on painting it) and/or waterproof caulking or sealant. To view the installation guidelines, please visit: https://images.homedepot-static.com/catalog/pdfImages/32/32c35c02-7fde-4e47-8de5-cb9543c48c25.pdf

A:  Construction adhesive like Liquid Nails has a slow setup time. That and a brad nailer. If you don't have a brad nailer, then you can use painters tape to hold each piece in place. Tape is tedious, but not too bad.

A:  You can install these using adhesive and nails.