Questions and Answers for Everbilt 3-1/2 in. x 5/8 in. Radius Chrome Security Door Hinge Value Pack (3-Pack)

A:  The Everbilt 3-1/2 in. Bright Brass 5/8 in. Radius Security Door Hinges Value Pack (3-Pack) is currently manufactured in China.

A:  Wood screw.

A:  The screw included in the Everbilt 3-1/2 in. Satin Nickel 5/8 in. Radius Security Door Hinges Value Pack (3-Pack) is a #9 x 1 inch wood screw.

A:  Yes, but best to remove existing center hinge and take it with you to match up.

A:  The 3-1/2 in. Chrome 5/8 in. Radius Security Door Hinges Value Pack (3-Pack) can be used to replace old hinges, as well as on new doors. Depending on the age of the old hinge, the hole pattern could be different and may require drilling new holes.

A:  Not sure how old your doors are. We replaced hinges on all the doors throughout the house 3 years ago. At the time our house was 11 years old.

A:  To remove the pin the hinge needs to be in the open position and then you can use a hinge pin punch to remove the pin.

A:  I did not remove the pins. I was replacing old hinges. I Installed the hinges on the door first. Then I shimmed the door close to position on the frame. By tipping the door slightly I was able to install the top screw on the top hinge. The bottom will be a little more difficult since can swing in two directions - you could adjust your shims or hold the door in place. Use a manual screw driver and place the screws in your predrilled holes. If not you will wish you had more hands. Pulling the pins prior to installation will require the side of the hinge with the four holes be securely attached to really heavy vice or screwed to a very solid work bench. then a nail screw drivee etc can be used to start the pin removal process

A:  To remove the pin you will need to have the hinge open. You can then use a hinge pin punch to remove the pin.

A:  Remove the bottom plug using vice grips and hammer. Hinges in the vice would help. Twist it and tap it and it will come out. Once the bottom plug removed, use a punch, long nail to push out the pin, clean it, lubricate it, and reinsert it.

A:  In order to remove the pin the hinge needs to be in the open position. You can then use a hinge pin punch to remove the pin.

A:  I think this is for indoor use only.

A:  These hinges are recommended for interior use, rust will occur if used in exterior applications.

A:  I used mine on the interior only, I'm not a 100% sure if you can use for exterior use

A:  This hinge is “universal”, the tab can go on either side.

A:  You should pop the cap off the hinge pin, remove the pin and put it in upside down. Don’t forget to put the cap back on. Now you can use the hinge the other way. I had this problem on one of my doors and found a YouTube video. I used a pair of channel locks to pop the cap off

A:  The door hinges are steel material with a satin brass finish. They will eventually rust in a moist and humid environment.

A:  They are made to last.

A:  I've had these for a little over a year all over my house, no color change yet.

A:  The finish should not change or tarnish in regular, room temperature conditions that are not exposed to moisture or moist air. For example, the finish will not last as long in a full bathroom.

A:  They appear that they will last. I have not had them long enough to evaluate.