Questions and Answers for Globe Electric Grayson 6-Light Brushed Steel Adjustable Track Lighting Kit

A:  Thank you for your inquiry. Yes you can mount this item on the wall. Best regards,

A:  Yes, this can be put on a wall.

A:  Yes, you can dim these lights.

A:  Thank you for your inquiry. Yes this is dimmable. Best regards,

A:  Thank you for your inquiry. Yes you can replace the halogen bulbs with LED bulbs. Best regards,

A:  Yes, you can replace the halogens with LEDs and I highly recommend not using the halogens, too hot. The suction cup for bulb replacement is useless. I'm still trying to figure out how to change out my halogens for LEDs. Your fingers cannot get in between the globe and the bulb.

A:  Thank you for your inquiry. The bulb is an MR16 "MR" stands for multifaceted reflector. GU10 is the base code for the bulb. Feel free to contact us at 1-888-543-1388 or info@globe-electric.com for any further questions you may have. Best regards,

A:  The arms swivel pretty easily. I can't recall if the pivots can be tightened--perhaps you could pose that as a separate question. If the pivots can't be tightened and you install this perpendicular to the slope, gravity will probably cause the arms to swing to the down-slope side. The steeper the angle of the ceiling, the more gravity pull there will be. If you install it parallel to the slope it will probably stay put, but in my opinion it wouldn't look very good. Otherwise, this is a very nice fixture, especially for the price. There is a lot of flexibility in aiming the individual lights.

A:  Thank you inquiry. There should be no issue with hanging this fixture on a vaulted ceiling. Best regards,

A:  Thank you for your inquiry. You can use either halogen or LED bulbs for this fixture, they are both offered in the required shape. Best regards,

A:  It would just depend. Like incandescent bulbs LED bulbs come in different shapes and sizes.

A:  I am hoping to never have to change the led bulbs. So I can't answer that question. However I think any bulb is hard to remove from any track lighting.

A:  Thank you for your inquiry. The brightness of the light from the fixture would depend on the bulbs being used. If you would like you can change the bulbs for some that are brighter or contact us for further information at 1-888-543-1388 or info@globe-electric.com. Best regards,

A:  I have mine installed in a walk in closet. It is plenty bright for that purpose.

A:  Mine lights up a dining area of about 20 feet by 15 feet very well. In fact two of them are aimed at the kitchen counters so the dining area is lit up well with just 4 bulbs. The lights are on a dimmer switch. I replaced the halogen bulbs that it comes with, installing dimmable LED bulbs, for the power savings and because the halogens run extremely hot (to me at least) although the halogen bulbs were just as bright as the LEDs. It could be that you have non-dimmable bulbs on a dimmer switch. That would make for dim light.

A:  Yes, with dimmer bulbs. We switched out to dimmable LEDs.

A:  Yes. We have a dimmer switch on ours

A:  Thank you for your inquiry. Yes, the fixture can be used with a dimmer.. Kind regards,

A:  I don't think so

A:  Yes, the arms swing--as I recall, as much as 90 degrees, maybe more. The hooded fixtures for each light rotate and tilt up and down. It's attractive, strong but not very heavy, and we're very happy with it. I installed it in an open-plan LR-kitchen-dining area of about 500 square feet. Several lights aim at darker areas of the kitchen counters. Three are pointing down, over the dining table, and two are aimed at sitting/reading areas in the LR. The halogen bulbs got very warm, as one would expect, so I replaced them for LEDs.

A:  Yes they are

A:  Yes, they can swing at least 90 degrees

A:  Thank you for your inquiry. The 2 track arms with 3 lights each can pivot on the canopy base. Best Regards,

A:  Yes, it is possible to mount this to a wall.

A:  Thank you for your inquiry. Yes, it is possible to mount this product on a wall. However please note that this product was designed for a ceiling application and not with intentions to be used on the wall. Best Regards,