Q:Could this be hung on the wall above a bathroom vanity?
by|Jun 14, 2017
3 Answers
Answer This Question
A: YES, BUT NOT TO CLOSE TO THE WALL. IT IS VERY BRIGHT AND WOULD NEED A HIGH CEILING FOR BEST LIGHTING.
by|May 4, 2023
A: This is a personal opinion, but I think it would be much better on the ceiling above the vanity. If you have enough room, you would probably want the most light possible, and would want a 4 foot by 1 foot fixture. That would give you great light for make up application and all the things you want good light for in the bathroom.
by|May 5, 2023
A: Yes. It fits in a space as limited as ten inches top to bottom.
by|May 4, 2023
Q:I can't get the diffuser off! I have all of the latches opened all the way to the left and I still can't get it off. Any suggestions?
by|Jan 5, 2017
1 Answer
Answer This Question
A: You don't want them all the way but sticking out/perpendicular. All the way goes past and re-engages the locks a bit.
by|May 4, 2023
Q:I just installed a LUTRON dimmer (TGCL-153PH-IV). A standard 100W led light works well with it, am I to assume that this rectangular flushmount would work also?
I have had a problem getting a dimmer that would work with led's.
by|Dec 5, 2016
2 Answers
Answer This Question
A: That dimmer is listed as compatible on page 7 of installation instructions: http://www.homedepot.com/catalog/pdfImages/6f/6f56b95e-0cfd-483b-8629-953b87427377.pdf
by|May 4, 2023
A: You would have to by a dimmer that is compatible with LED. We just remodeled our house down to the studs and installed many dimmers. Our electrician told us about the LED dimmers available at Home Depot. There are regular ones, LED exclusive ones and LED/Reg combo dimmers. We went with the LED ones, because we transferred our whole house over to the energy saving (and wallet saving) LED lights and bulbs. Hope this helps.
by|Dec 27, 2018
Q:can you hard wire this directly with a bx connector
by|Jun 16, 2016
3 Answers
Answer This Question
A: It needs to mount over a box.
by|May 4, 2023
A: Yes, I did.
by|May 4, 2023
A: Yes, the LED flushmount can be hardwired.
by|May 3, 2023
Q:Product Features state "No Bulb Included" and also "No Bulb Required". So, while a LED is not technically a 'Bulb' - how many are there? Are the LEDs included? Locations or mounting pattern? LED type. Are the LEDs permanently wired / installed or individually replaceable in sockets? Thanks.
by|Feb 24, 2016
1 Answer
Answer This Question
A: They look like little computer chips taped down around the outer edge.