Questions and Answers for Makita Big Bore 5.2 Gal. 140 PSI 3.0 HP Portable Corded Electric Horizontal Single Tank Air Compressor (6.5 CFM at 90 PSI)

A:  Thank you for your question on the Mac 5200 big bore. This tool produces the following. Performance (90 PSI) : 6.5 CFM. With a Maximum Pressure of : 140 PSI

A:  Yes it produces 6.5 cfm at 90psi

A:  That sons like a resounding “No” from Makita concerning the higher value cfm. Way to deflect a straight answer Makita guys. ?

A:  Thank you for your question on the MAC5200 air compressor. To better assist you with your inquiry, please call the Makita Call Center during business hours at (800)4-MAKITA, they’re based in Flowery Branch, GA, and are more than happy to help.

A:  Thank you for your question. The MAC5200 5.2 Gal. 3.0 HP Single Air Compressor uses air compressor oil part number 181122-A (1 quart) and the amount needed is 10 Ounces.

A:  Thank you for your question. The MAC5200 air compressor is designed with a powerful 3.0 HP motor and produces 6.5 CFM at 90 PSI for increased productivity. For more information, please refer to the following website www.makitatools.com/products/details/MAC5200

A:  6.5 CFM. Strong air compressor. 

A:  Thank you for your question on the MAC2500. This tool uses a 1/4 air hose. Please visit https://www.makitatools.com/products/details/MAC5200 for more specifications. This tool runs at 6.5 CFM @ 90PSI; Powerful enough to run two framing nailers.

A:  Thank you for your question on the MAC5200 air compressor. Yes, the attachments are for 1/4 inch insert.

A:  Thank you for your question. The MAC5200 Air compressor has a powerful 3.0 HP motor that produces 6.5 CFM at 90 PSI for increased productivity, enough for two Nailers. Please refer to your instruction manual for any compatibility questions.

A:  Thank you for your question. The MAC5200 5.2 Gal. 3.0 HP Single Tank Air Compressor uses air compressor oil part number 181122-A (1 quart) and the amount needed is 10 Ounces.

A:  Thank you for your question on the MAC5200 air compressor. There is no published spec on the height of the handle in the upright position. Local dealers with this product in stock may allow you to get an exact reading but It is approximately 35".

A:  You are right. I was not able to run this on a 5500 watt generator, plugged directly in. No extension cords. It is also beastly heavy if you have to lift it, and makes lots of noise compared to my brothers Makita air compressor of a discontinued model.

A:  Thank you for your question on the MAC5200 air compressor. This tool produces a maximum horsepower of 3.0. with a minimum Circuit Requirement: 15 AMPS.