A: Hi Leah, all the parts required to install this unit to your home is included with the unit. Please refer to the Use and Care Manual for installation instructions. Thank you.
by|Mar 24, 2024
Q:How far apart are the water lines?
by|Mar 21, 2024
1 Answer
Answer This Question
A: Hi Bill and thank you for your question. The Height to Cold water Inlet is 5". The Height to Hot Water Outlet is 22 3/4".
by|Mar 22, 2024
Q:What size breaker is required for the Rheem Performance 20 Gal. Compact 2000-Watt Single Element Point-Of-Use Electric Water Heater?
by|Mar 8, 2024
1 Answer
Answer This Question
A: Hi Turnr, a single pole 25amp breaker is required for a Compact 2000watt Point Of Use water heater.
by|Mar 10, 2024
Q:I want to install under cabinets in a corner 27 X 27 space. My house HWH is in the garage and takes about two minutes to reach the sink and dishwasher. I want to connect the inlet to this heater from my house heater so that hot water. Is this OK?
by|Mar 3, 2024
1 Answer
Answer This Question
A: Bill, Thank you for your question. Locate the water heater in a clean dry area as near as practical to the area of greatest heated water demand. Long un-insulated hot water lines can waste energy and water. Place the water heater in such a manner that the thermostat and element access panels can be removed to permit inspection and servicing such as removal of elements or checking controls. The water heater and water lines should be protected from freezing temperatures. Do not install the water heater in outdoor, unprotected areas. Make certain the floor underneath the water heater is strong enough to sufficiently support the weight of the water heater once it is filled with water.
The water heater should not be located in an area where leakage of the tank or connections will result in damage to the area adjacent to it or to lower floors of the structure. Where such areas cannot be avoided, it is recommended that a suitable catch pan, adequately drained, be installed under the water heater.
by|Mar 4, 2024
Q:What size wired plug comes with this?
by|Mar 2, 2024
1 Answer
Answer This Question
A: Hi Arland and thank you for your question. This unit does not come with a plug - Power cord supplied with 2.5 gallon models.
by|Mar 4, 2024
Q:If I empty the tank, how long will take to have hot water again? On a 20 gallon tank water heater
by|Jan 30, 2024
1 Answer
Answer This Question
A: Shawn, Thank you for your question. Without knowing your set up or how cold your water is going in it is hard to determine for sure but we estimate anywhere from 60-80 minutes.
by|Jan 31, 2024
Q:Can a electrical cord be connected to this heater and plugged into an 120V outlet?
by|Jan 21, 2024
1 Answer
Answer This Question
A: Hi JayW and thank you for your question. The Power cord supplied with 2.5 gallon models only. The rest need to be connected to the junction box.
by|Jan 22, 2024
Q:How do you drain the tank so you remove the element?
by|Jan 19, 2024
1 Answer
Answer This Question
A: Hi David, you can find instructions on draining the water heater in the Use and Care Manual. Otherwise, feel free to contact our Customer Support team and we would be happy to inform you further. Please contact us at 866-279-4566, thank you.
by|Mar 29, 2024
1 found this answer helpful
Q:How do you drain the tank so you remove the element?
by|Jan 19, 2024
1 Answer
Answer This Question
A: Hi David, you can find instructions on draining the water heater in the Use and Care Manual. Otherwise, feel free to contact our Customer Support team and we would be happy to inform you further. Please contact us at 866-279-4566, thank you.
by|Jan 21, 2024
Q:What is the heat ailment model number element should be element number for Richmond model 8ZP 20–1 serial number RM129730804, water heater