Q:Can the trim kit be added after the oven has been installed?
by|Jul 16, 2023
1 Answer
Answer This Question
A: Yes, this can be installed after you have already set up your wall oven.
by|Nov 7, 2023
1 found this answer helpful
Q:I need to fill a 10" gap above the summit oven... Could I stack one on top of oven and the other below the oven? Or even stack these on top of each other to fill the 10" gap? Pls. advise!!! Thank you.
by|Nov 22, 2022
0 Answer
Answer This Question
Q:What is the difference between the two black trim kits? One is 85.00 & one is 95.00 . Will either one work for an Empava wall oven?
by|Jun 3, 2022
0 Answer
Answer This Question
Q:Is a white trim kit available? I only see Stainless and Black.
by|Nov 5, 2019
2 Answers
Answer This Question
A: Hi Jack, thank you for your interest in Summit Cooking. The wall oven trim kit is currently available in black or stainless steel only.
by|Nov 12, 2019
A: No, only available in black
by|Jan 21, 2020
Q:Do the trim kit go on the top or bottom?
by|Mar 2, 2019
3 Answers
Answer This Question
A: The trim kit fits above the oven.
by|Jan 6, 2024
1 found this answer helpful
A: Bottom
by|Dec 30, 2023
2 found this answer helpful
A: It specifies above the control panel (and also has screws that go into the top of the unit).
by|Dec 13, 2019
1 found this answer helpful
Q:Can you use this Summit wall oven trim kit on a Electrolux/Frigidaire 24" Wall Oven Trim Kit same size 24 inch gas wall oven
by|Sep 23, 2018
2 Answers
Answer This Question
A: Yes, this product can use in an Electrolux/Frigidaire 24" Wall Oven Trim Kit same size 24-inch gas wall oven.
by|Jan 4, 2024
A: Possibly? But I do think it has specific screws that attach to the Summit oven itself in the instructions. If you didn't want to attach it, it might be a good fit ... no promises though.
by|Apr 4, 2019
Q:Can this piece be used on the Bottom of a Cosmo wall oven to fill a gap. We are replacing a much older oven that was 5 1/4 " higher. Need to put on bottom because oven is two low if left where it rests on existing opening.
by|Aug 19, 2018
2 Answers
Answer This Question
A: The piece is 4 1/2 inches and has screws that attach to the top of the oven. I doubt if it is designed to support any oven (not sure of the weight of yours, but the Summit is at least 100 lbs.
by|Apr 4, 2019
A: The Trim Kit was specifically designed to pair with Summit wall ovens that are a width of 24". We cannot guarantee that it will appropriately pair with a wall oven outside of what has been tested.