Customer Reviews for Artika Medium Glowbox Stainless Steel Outdoor Integrated LED Wall Mount Lantern

This contemporary wall sconce looks great and is made of sturdy stainless steel and heavy opaque glass diffuser. It can be mounted on a single rectangle box or 3" or 4" round ceiling box. It has the typical round mounting plate that allows several locations to put your screws. The screws are already attached to the plate and a nut locks it in place so you can mount the light by putting the fixture over the studs and insert the thumb screw nuts and plastic washers. You just lift up the glass diffuser to get to the mounting hardware. The light is not very bright, but it works well as a hallway sconce or front door light.

This MEDIUM GLOWBOX STAINLESS STEEL OUTDOOR INTEGRATED LED WALL MOUNT LANTERN arrived quickly and was a little over packaged as it took twenty minutes and a few cuts on the sharp metal edges to even get it open. It's a heavy fixture that is a little rough around the edges. It installed in the usual manner and looks nice from a distance and works quite well once installed. It's an "outdoor" lantern , but is nowhere near water or rain proof so a protected area is a must.

This review is for the Artika Model GB600L-C1SS Medium Glowbox LED Wall Mount Lantern. It has the following specifications and features: 600 Lumens light ouput (the equivalent a 51 Watt incandescent); an integrated LED rated for 25000 hours life; suitable for Indoor/outdoor use; 26-Watts power consumption; and weather resistant rust proof stainless steel construction. Installation was easy, a ground wire to the grounding screw, and connect up the hot and and neutral, but you will need to reuse any existing wire nuts or replace with new. None were included. Another fly in the ointment was a missing knurled thumb nut that secures the fixture to the mounting plate. The stud turns out to be a metric M4-.7 mm, so I needed to make a trip to the store for an appropriate substitute. A wingnut didn't fit (I tried), it was too close to the lighting element to turn, so I used a regular hex nut. Once you install the frosted glass diffuser, you can't see the substitution. You can see from the pictures what it looks like installed. The light bars you see are not visible to the eye. Presumably some (60 Hz?) synchronization artifact between the camera and the light, but the spec sheet doesn't give any hints. It is a good looking light, the light is bright and nicely diffused by the cover.

This Artika wall mount light comes well packaged, with instructions and hardware for its installation. The installation is easy, I like the paper used for the instructions, installed in the junction box and that is all. The light itself has a very attractive stainless steel finish and it is complemented by the frosted glass shade. I like that it utilizes LEDs and these are integrated already. It can be installed outdoors as well as indoors since it does look modern and warm at the same time. The light is of 600 lumens at 3000k temp color. Overall it has a very nice design and ecofriendly.

+ the best of intentions - seamed, painted glass - three glass pieces will separate completely during install (welded together with paint) +/- should have broken glass several times during install I just moved into an all-brick townhouse with bad racetrack, bad wiring, bad fixtures and bad air conditioning, so I spent a very unpleasant week putting up LEDs and ceiling fans on racetrack boxes whcih are extremely unforgiving of any hiccups. I'm also wiring in wifi modules that have to be hidden along with my 14g wiring, the existing 26g SPEAKER WIRE and any AIO LED driver. This driver isn't as unnecessarily big as most AIOs, which won't matter to anyone not using racetrack or wifi modules, but, the glass is three pieces, beveled together and held in place with white paint on the inside. When they inevitably break apart, you see the beveled greenish-glass seams -- the light is bright enough to blow that away when lit, but even with other anemic LED in my kitchen I can see the seams from across the room when it's unlit. Which is a shame, because when it first arrives you can't see any hint of glass, which is why the actual design surprised me so much: I was expecting a plastic blown lens or something. This is the ONLY fixture of many from Artika that left me disappointed. Glass is almost always preferable to poly-anything in lensing, but not in this case.

Artika Glowbox in Stainless Steel is Stunning. Real Stainless makes this Light Stand out from other lights. The LED panel of lights are a Great way to get Brightness and a lot of hours all in one panel (600 Lumens and 25000 hours). Heavy Duty Stainless and High End Product. I like the Easy Slide off Lens for cleaning. Awesome Light. Going up in the hallway.

The “glowbox”, is the perfect addition to our lanai. It is for inside or outside. Made of stainless steel, so no rust in the future. Glass is thick and frosted We added a dimmer to this. Make sure you use the right dimmer for an LED product. Installation was easy, if you know a small amount of electrical work. It looks great, is very stylish, easy to install.

This stainless steel glowbox was brighter than I expected, and this is a plus. Also, the light produced is a warmer color than the more bluer daylight bulbs. Works very well as a nice ambient light that is also bright enough to light up a room. It is advertised to be able to be installed outdoors and the light is weather resistant. Initially, I was going to install this indoors to light up a stairway, but unfortunately, the placement of the electrical box was too close to the ceiling so I was not able to slide the glass cover into the glowbox. Because of this, I will use it outside in my backyard since that light can use an upgrade. Fortunately, this glowbox was very easy to install as well as remove. The instructions provided some very important and helpful tips like keeping the plastic bag on the glass cover when sliding it into the glowbox, and then afterwards remove the bag. One thing to keep in mind is to make sure there is enough clearance above the glowbox so that you could slide the glass cover into place.

Good for a few years then garbage. Only run 6 hrs a day

Love the design. Have to return because they weren’t dimmable.

Has a weird yellow glow. Need a clockworker screwdriver. 4 micro screws on the side made it very difficult to reinstall light cover.

Modern and clean look. Very elegant

Nice light but wish it had motion option

Brighter than I thought, but I really like it

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Good light and fits close to house, husband no longer hits his head. Nice modern look.