Customer Reviews for DIABLO 8-1/2in. x 60-Teeth Fine Finish Saw Blade for Wood

The blade didn't last very long. Actually the last 4 I've purchased haven't lasted very long. Fortunately for you I can't find that size anywhere else.

Cost too much over priced

Nice blade, no vibration and an excellent smooth cut on my counter tops and cabinets.

Nice smooth cuts

Great blade-worth the price!

Rating provided by a verified purchaser

Great tool. Cutting laminate wood floor planks, minimal chipping was seen. Nice clean cuts.

This blade gives smooth cuts in Western Red Cedar and I expect most other woods. Used in a Makita sliding compound miter saw it provides fast smooth cuts.

it cuts wood,and aluminum

Blade was purchased to cut prefinished oak flooring It's a clean cut and cut like butter when new. At the end of 800sqft it was a little dull .

Great for my miter saw, smooth cutting, great value

First off, this was the only blade i could find that would fit my el- cheapo miter saw. ( needed 8.5 inch diameter). I also wanted to use this miter saw to cut numerous pieces of aluminum carpet transition strips. Nice smooth cuts without any vibration or kickbacks on the aluminum, even while making 45 degree angle cuts. Made it very safe to use because it is a finish blade. I may leave it in and use it for other wood products later on. Good purchase.

Clean cut fits perfect!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!)!!))))))!!!!)

All diablo blades are excellent

I am using this on a 1950s-era Craftsman table saw. It has been great at crosscutting small wood items and at cleanly cutting plywood. The blade is heavy but thin.

Always get this blade for my skill saw, this blade lasts for the things I cut. Not the most expensive blade but it is durable and gives me a clean straight cut everytime.

My Hitachi chop saw works really well nice quality in each cut

This blade performs very well and gets the job done! Makes cutting easy and quick and this helps when don't have a lot of time, and don't want to make mistakes. I would buy this brand again if needed.

left a very smooth edge. very pleased with the out come from this blade

I’ve used one of these blades on my miter saw for about five years now without any issues. I own a 9” table saw and its getting harder and harder to find blades. I picked up another 8-1/2 IN. X 60 TOOTH CARBIDE CIRCULAR SAW BLADE for use on my table saw. So far it performs well with soft and hard woods. It excels at cutting plywood. The only issue I've found is the blade is thin kerf which throws off the measurements on my saws’ fence slightly.

Clean cut, Runs smooth, Last long It is a good blade for general purpose cutting.

My sears compound mitre saw has a somewhat unusual size, but this fits perfectly and is making excellent cuts.

cut smooth and clean, no splintering

I just love the blade as i find this to cut an accurate line...very stable extremely sharp...the coating works with the hardest wood... a good buy