Assembly was not too difficult but I almost mounted the center panel in the wrong location, which...Assembly was not too difficult but I almost mounted the center panel in the wrong location, which would have put the drawers on the wrong side for my application. After correcting that, before the glue set up, I was able to put it together without too much trouble. The unit is melamine covered particle board so I caulked the inside seams to insure that any possible leaks would not cause any swelling. Drawer slides have a rubber ring on the wheels that seem to make them roll more silently. A nice idea. One of the cam locks broke during assembly but Design House was able to send me a replacement within a few days. I was surprised, since they are a distributor and not a mfr. I did buy different pulls so I could recess them into the drawer fronts to allow the door to our half bath to open. Overall it is a nice product. The holes for the screws are predrilled so that helps make the assembly easier. I only had to drill 2 holes for the door hinge bases because 2 of the 4 existing holes did not line up with the holes in the hinge. Not a big deal. Just make a slight hole into the wood and the screws go in easily. Be aware that the drawer fronts will be flush with the cabinet side. If mounted next to a wall an the drawer side the drawers will rub the wall. I added a 1/2" piece of Azek scrap I had to space the cabinet away from the wall. Color is slightly off but works great.
by MrD