1/4 20.. cant go wrong here. Good for small projects assuming you remember to buy the bolts(or th...
1/4 20.. cant go wrong here. Good for small projects assuming you remember to buy the bolts(or the ones you have are long enough...).
OR you were in a rush and ment to get 1/4 washers because you already have 2 boxes of these(now i have three!).
There will always be a project that will use these so the more the merrier!
The Everbilt Brand, 25-Piece per Bag 3/8 in. 16 TPI Zinc-Plated Hex Nuts meet my needs for genera...
The Everbilt Brand, 25-Piece per Bag 3/8 in. 16 TPI Zinc-Plated Hex Nuts meet my needs for general fastener use where grade five or higher are not mandatory. I find these nuts take high torque very well without yielding or stripping. In the photos below, two of these nuts, lock washers, and corresponding Everbilt cap screws have been used to retain a 60-pound lead acid battery and tray resting on top of a RV frame rail. All the fasteners used in the fabrication of the battery tray are Everbilt brand.
Must have for every DIY'r. 3/8-16 is one of the most common thread sizes found in the U.S. househ...
Must have for every DIY'r. 3/8-16 is one of the most common thread sizes found in the U.S. household and you can never have enough hardware in your garage or shop. This is a common nut for general commercial use considered a grade 2 or maybe a 5. I say this because the OEM does not state the grade so you must assume the lowest. Higher grades demand more money and the OEM would definitely state the grade in order to justify the price. Never replace a higher grade nut with a lower grade, bad things can happen.
The zinc plating for corrosion resistance is uniform and well applied, starting threads do not have any burrs, overall a good product, recommended.
Well made and a good price
Inevitably I will drop a fastener when I am working on a project and it will find a way to a place I cannot access or disappear entirely. And the nearest hardware stores are about thirty miles away. So it makes sense for me to keep spares in my hardware bins. Buying by the bag is the way to go for me, especially at the price point for this item.
The nuts themselves are well made, threads and sizes are consistent. I have had no problems with any of them.
The 3/8" Zinc-Plated Hex Nuts will be added to my hardware collection. When you own a home and al...
The 3/8" Zinc-Plated Hex Nuts will be added to my hardware collection. When you own a home and also do a few handyman chores for friends and family-you can never have too much hardware in your garage or shop. I like the quality of the "Everbilt" brand. This is usually the brand I purchase when I go to local/favorite Home Depot. Sometimes I just make a pass thru the hardware section and grab a few items for "just in case" projects. Great product.