#1 Home Improvement Retailer

Customer Reviews for Everbilt 1/4 in. x Close MIP Brass Nipple Fitting

Internet #207176749

Model #802629

Store SKU #710684

Customer Reviews

  • 4.7
    out of 508 reviews
  • 94% recommend this product
Filter by:
Showing 1-10 of 508 reviews
Just what I needed...
Just what I needed
by VERONIKA
Seems silly to give a brass pipe a review :) Works like a pipe, threads like a pipe... used it to...
Seems silly to give a brass pipe a review :) Works like a pipe, threads like a pipe... used it to build a DIY spigot that's hidden in bushes for front porch.
by Jh
Perfect for my rain shower...
Perfect for my rain shower
by MyLyfe305
It's a strong metal and works perfectly for any plumbing job where you need a 6 inch long and 1/2...
It's a strong metal and works perfectly for any plumbing job where you need a 6 inch long and 1/2. Inch thick.
by ANGEL
It served me very well as I was changing waterheater valve. Good fitting and sturdy material.
It served me very well as I was changing waterheater valve. Good fitting and sturdy material.
by HomeDepotCustomer
Used to add a water pressure gauge to a well pump. Needed it offset from the main line so I coul...
Used to add a water pressure gauge to a well pump. Needed it offset from the main line so I could see/ monitor the readings. The threads on the two (2) ends of the pipe nipple have a different number of turns (!?!). So, the male end with more turns leaked a little. Did not want to crank down more on the female connection so more Teflon tape improved the situation; leak is tolerable but not completely fixed.. Will have to go back to Home Depot for another one on my next trip there. Will pay more attention to this possible defect when purchasing.
by eagleh42
Full filled the requirement of the job
Full filled the requirement of the job
by
1 person found this helpful
I purchased 2 of these brass nipples, and one of...
I purchased 2 of these brass nipples, and one of them leaked through the threads. After inspecting I found 2 gouges inside of the nipple which was deep enough to cut through the threads. Home Depot made things right by swapping it out for a new one, but it still cost time and labor.
by Kyle
2 people found this helpful
Natural gas is normally run through an iron pipe, but when plumbing an outdoor grill, iron rusts ...
Natural gas is normally run through an iron pipe, but when plumbing an outdoor grill, iron rusts (even if painted). So where it is visible, switch to this brass pipe, and the installation will look great for many years.
by DIYGuy
1 person found this helpful
The close makes a difference! I used this one to connect a whole-house water treatment system, an...
The close makes a difference! I used this one to connect a whole-house water treatment system, and the extra little bit of saved width to the overall system does make a difference for servicing our filters—the left-most filter would have been more difficult to remove if I had to move the whole system towards the water heater. I used thread tape on both sides, and tightened it up as a whole system using the street elbow. It has been over a month and I don’t have any issues. Lead free is a must for our water supply.
by 59ona64
Showing 1-10 of 508 reviews