Customer Reviews for Everbilt Gas Water Heater Installation Kit

Exactly what I needed to make the install of my new tank easy and effortless.

This kit has everything a person needs to replace a hot water tank, it took no more than 30 minutes to install !!!!!!

According to National Fuel Gas (utility supplier), they discourage flex gas lines and recommend (or require, depending on locality) hard gas pipe. I did have a leak with the flex connection post install that I was able to correct. The issue was with the flare fitting

I am happy with it, it was the less expensive unit, which I knew and it works just fine.

I ordered this for my daughter who lives in another state. I gave it 5 stars only because she was able to get her water heater installed and working again. So I am assuming the kit worked as it should.

Flex line leaked at the o-rings

Followed specific instructions on installing these hoses and they leaked! Do not recommend them.

I bought this as a suggested add on for a new water heater. However, the water lines are only good for a straight line or minimal curvature. The gas line had smaller fittings than my old hot water heater. As I had opened the package while installing the water heater, I ended up tossing all of it into the trash. Buyer beware. Convenience is not always convenient! What a waste!

This is a good refit kit. It contained all that was needed for a new tank installation.

I tried 2 sets of these and they all leaked. Wasted hours of my day. Now I have to install a 3rd set. I will never buy this brand of cheap Chinese crap again.

Everything fit and was easy to assemble

one of the supply lines leaked at the crimp, on both ends !!. This is a complete set and did make the job pretty straightforward. As always had to make another trip to replace the leaky hose.

Having a ton of issues with it and returning the tank for a new one.

Could not stop the hoses from leaking.

The water lines were not flexible enough and kinked, and the gas line was too short.