Slide-in installation fits most standard sized doors
PVC door-bottom mounting is abrasion-resistant
Compatible fitting with saddle-type thresholds
out of 105 reviews
59% recommend this product
Showing 1-10 of 105 reviews
Jun 3, 2020
Easy to install and clear so it looks nice!...
Easy to install and clear so it looks nice!
Jan 30, 2018
Clear plastic 36 inches long and will fit on doors between 1 and 1.75 inches thick.
No 'one time' adhesive tape strip. If you need or want to reposition or trim, not a problem.
Seals on both sides of the door. See the profile picture, it was impossible to get a profile picture of it on the door.
Easy to cut with a good pair of scissors. If the inner or outer sealing edges are in the way, easily trimmed.
This is designed for doors with a large ~3/8" gap at the bottom.
My garage door has <1/8" gap at the bottom, it was impossible to close the door with it installed.
I used it on my basement door that has a large gap, not so much for cold air, but to cause the HVAC to draw from the return vents rather than under the door.
I thought this would be the perfect replacement for my entry door from the garage to interior lau...
I thought this would be the perfect replacement for my entry door from the garage to interior laundry room. However, after cutting it to size to fit the width of the door (30"), I had difficulty keeping the channel even and level from left to right . If I got it snugged on the right side, it would not stay snug to the other side no matter how much finger pressure I put across the bottom to even the line up at the bottom of the door, plus as I tried to close the door, the whole channel moved from where I located it to the left. The only way to get this EZ-ON to stay flush with the bottom would be to screw it onto both sides of the door, which was not the intention of this design door bottom. Also, once I had it in place, the door would not close at the hinged side of the door where it meets the saddle on the floor. I tried cutting the vanes at the bottom of the right side from the garage side and it still wouldn't allow me to close the door. This EZ-ON just did not work as designed and I ultimately had to get the regular style sweep door bottom which required screws, which then had no problem to seal out the cold or close the door.