Appearance of these is just fine. They look nice on our cabinets. I am giving it low marks on qu...Appearance of these is just fine. They look nice on our cabinets. I am giving it low marks on quality because the hole spacing is NOT 3 inches, it is 75 mm. Close, but 0.046" off. That doesn't sound like much unless your cabinets are already drilled at 3 inches. Enlarging the holes in the doors/drawers will provide enough slop, but the profile of this pull around the screw holes is pretty narrow: the width at that point is 6 mm or about 0.236. That would be enough to cover a 7/32" hole in the door/drawer, except with many of these I found the holes were not centered in that 6 mm space. A 3/16" door/drawer hole doesn't provide enough slop, 13/64" is still too tight. So 7/32" is the only option, with a little peek-a-boo around those handles with the off-center holes.
All this being said, these are very inexpensive and the cabinets they are going on are not great. So we are drilling the cabinet holes out to 7/32" and ignoring the
by cheffromage