Customer Reviews for Insulfoam Garage Door Insulation Kit

All the boards were warped except 1

Great product

Easy to install and the garage is staying cooler

Easy to install, they look great and the garage is much cooler

very easy installation once you put up your first panel. Works well can notice a decrease in temps in my garage.

We were able to measure, cut, and install very quickly to insulate the garage door quickly with this insulation kit. In Vegas, the protection from extremes is important and I am hopeful that this will make a difference to my overall home heating costs.

High quality and easy to cut. Perfect fit

The product was precut and fairly easy to install. It did weather proof the garage from heat or cold.

Very very expensive for what you get....but have no choice as I cannot carry full sheets in my car and Home Depot will not cut down the full sheets at store. Delivery is even more expensive. If you have a pick-up truck, great for you. Product itself is fine, same as full sheets.

Exactly as described online and in store. Easy to install 2 kits in double garage that gets too hot to touch with sun on it. Garage is cooler and an added bonus it is a bit quieter inside.

Easy to use. Saw an immediate impact in temperature reduction.

I would give this a much better rating but the pictures that you see on the left are deceiving. These Boards DO NOT BEND! as the pictures and Insulfoams Video indicate. Perhaps if they did it would take only an hour to install (per the insulfoam video). They do not have the deep and several grooves that would allow these boards to bend. There are about 4 slight grooves that are not that deep and if you do try to bend these boards they will break. So basically you have to cut them to fit. Which is what the directions on the box indicate (ignore the pics and try to read the box). I think Insulfoam changed their product and doesn't bother to say so. The pictures and the video are a LIE! These will take you a good amount of time to install. In fact I not only had to cut the sides but because they don't bend I had to trim the tops. So then you may as well buy the 4X8 panels for a Fraction of the price you pay for these. Which is what I wish I had done. As someone here also said...It's just Styrofoam. Buy the 4x8 sheets. It will give you the same insulation for fraction of the price you'll pay for these And its the same amount of work!

The product is good but the installation got a little complicated because my garage door panels are 1 inch wider than the panels in the package. Instead of having to trim one panel to size and then mount it in landscape mode, I had to cut 3 pieces in portrait mode so they would be held in top and bottom. The package says can be installed in one hour. Probably true if you don't have to do a jigsaw puzzle. The panels do keep the garage cooler, no question they do work.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Rating provided by a verified purchaser

This product worked very well and was easy to install.

It clearly took more time then stated about 5 hours. Found it was helpful to have a longer brake off knife and sheetrock square. I used the spray crack filler foam at the panel insets. Cut them about 1/4 shorter I was able to bend them in tight and the foam tighten them up. They clearly made the garage tighter and warmer. Found them on clearance with a rebate. All and all a good product for the price I paid

Product works great but not a 1.5 hr job...the sheets were thicker than our door channels and longer so it took a lot of cutting and resizing to get them installed. We ended up using silver heat duct tape to seal the edges. Even though it took a lot of time and effort, I would highly recommend.

Works very well. The vinyl front was what makes this product look better than others on the shelf. Made cutting easy. I would like to see all 16 in one bag, rather than having to buy 2 bags to fill a standard 2 car garage. The bag only holds 8.

THE INSULFOAM KIT EXCEEDED MY EXPECTATIONS. WAS EASY TO INSTALL AND HAS DECREASED THE GARAGE TEMPERATURE BY SEVERAL DEGREES. WOULD RECOMMENDTHIS KIT TO ANYONE INTERESTED IN INSULATING THEIR DOOR. SEEMS TO BE A GREAT PRODUCT.

A little difficult fitting the pieces into the door, but after removing the cross supports they went in with a little bit of work. Seems to help cool the garage some.

Good product......Suggest you add adhesive center support tabs for the panels.

Installation was super easy all you need is box cutter and measuring tape!!!

Worked as advertised

I debated between buying 4x8 sheets and cutting them myself to save some money but I decided to go with these and I am very happy I did. They're well worth the price difference. The relief cuts on the back of these make them super easy to bend and install and the white finish on the other side looks very nice and professional. The door looks almost like it came insulated from the factory. I used two of these kits and completed a 16x7 door in about an hour. I used an infrared thermometer on the door before I installed the panel and it measured 132F with the sun directly on it. After installing the panels, the door measures 92F. Great product and easy install. I recommend this highly.

This product seems to have made an 8-10 degree difference in the garage. I have been checking each day with the same outside temp, at the same time and it ranges from 8-10 deg cooler. Wasn't too difficult to install, don't buy the 8x10 sheets, these kits are already pre-cut on the backside to assist with bending and fitting. It was worth the price difference. I do recommend the items x 2 for a standard 2 car garage. Also, MAKE SURE you have a very sharp blade/knife. I do not recommend you use a carpet knife, doesn't cut deep enough so you have to make multiple cuts, equals more mess. cheers and good luck.

This product was easy to install and did reduce the heat in our garage. A couple of caution notes during installation that turned up; one being you have to measure each panel/space on your door, they may look the same but they generally aren't; second is the panel ends at each end of your door; it takes a a bit of measuring and cuts to get these small pieces to fit correctly. You could skip this step, but it is worth the extra effort.

Messy, but easy to cut and install

Easy to cut, but difficult to install in certain instances.