Customer Reviews for Loctite TITE FOAM Gaps and Cracks Spray Foam, Bright White, 12 oz. Can, Insulating Spray Foam Sealant

Do not use this brand. The spray nozzle breaks easily rendering this can useless. Use a different brand. The instructions were easy to follow but the trigger is easily broken.

this The product is a one-time use! The manufactory doesn't mention it on the bottle. it will mislead customers to make a mistake

The foam came out every where but the nozzle. I destroyed a pare of leather gloves, a sweatshirt and a hat. This a worst product I have ever used.

This product is a complete load of crap. Despite me following all the instructions, it would not spray evenly. It feels as if I was spraying whipped cream. The foam that comes out does not stick to anything and just lumps around, leaving a sticky mess. This stuff is so hard to control that even after I put it to the side, and tried to remove my gloves, any piece of residue that were on the gloves themselves just immediately stuck onto each other and transferred into my hands.

I bought 4 cans of this and none of them were any good. Leaking through the top nozzle or not enough propellant to push it out of the can..Drove 10 miles twice to buy it. I wrote the company "Henkel" but their automated response was the cans were over 15 months old. A total lie. I just bought them. This is what happens when a company is too big, they lie right to your face..I will go out of my way to NOT purchase any Locktite product, ever again. Please Henkel no need to reply with your automated response. Your product cant deliver and you know it!

Just bought this to fill a few cracks in basement. The lid doesnt fit tight enough and the foam explodes all out from can opening and not the straw provided. Huge mess. Complete waste of time and money.

I have the same issue that many others have. Very little foam came out the applicator No matter what I did it came out of the fitting around the trigger, What an waste. The trigger was properly clamped and secure. I am not a newbie with spray foam. I tried to make it work to get some Foam out of the straw and I got about 4 ounces out of the straw the rest out of the fitting. Returning and go back to great stuff. Very disappointed in Loctite.

Absolutely a garbage product. I attached it according to instructions and made sure it was tight. The spray didn't come through the straw, it came out of the fitting. Got all over my hands and took hours to scrub off.

Has this nozzle with flexible plastic. Problem is the foam breaks through it and makes a giant mess.

Total waste of money. The only place foam left the can was through the base of the valve. I had to squeeze the daylights out of the trigger but nothing happened. I tried squeezing each side individually and both sides at the same time. Nothing worked. I took the straw off the valve and tried to push the valve sideways by hand. That worked a little but the foam started coming out from the bottom of the valve instead of out the top. Completely useless design.Never did get to use the product.

The nozzle on the can was worse than useless, the spray foam was entirely deposited on my hands and on the can, DO NOT BUY THIS PRODUCT unless what you want is a huge mess, the nozzle on this thing makes the foam inside useless

Would not recommend lepage tite foam bought a can to do around the windows and the can didn't do one window the product is a waste of money

Been using this as my choice foam, since it has great density. But recently, I've seen further improvement to the packaging to include breakaway plugs so you can use the can multiple times instead of the normal 1-and-done. Smart innovation. Five Star.

Bad spray design and form came out at the lever, not the tip. No use after.

I got a few second of foam out of the nozzle and then it started coming out of the can/nozzle connection. I had foam on my hands that was impossible to clean off. I had to wait 2 days for it to wear off. Threw away almost a full can into garbage.

Connection didn't stay together Keep coming apart Only got to use a small amount until the sprayer broke altogether On both cans I bought

On first use, foam leaked from where the nozzle goes into the can. Leaked around the shaft that goes into the can. Product works great…IF you wear rubber gloves and scoop off leaked foam from nozzle to can area and apply it to area being sealed. Next day, peeled off dried foam from around leak area and tried spraying it again…same problem. The shaft going into the can, bends when trigger squeezed, allowing foam to leak.

Bought three of these cans online and two in store. Cans are defective. They require A LOT of force to start dispensing foam. Of course after a couple of attempts, the white nozzle that the dispensing tube screws into broke off. Two cans failed this way after dispensing maybe 10% of the can contents. Do not buy. Can I get replacements or my money back?

We used this foam to seal up a gap along the wall our garage where pests were making their way in. Application gets a little messy towards the end of the can, but we followed the directions, sprayed slow, no issues that I read on other reviews

We purchased 5 cans of this product. HIGHLY DISSATISFIED!! The foam hardly expands at all. Worse though, out of 5 cans we purchased, two cans' dispenser tips snapped off as soon as we tried to use them. Both cans full but unusable. Can NOT recommend!

The foam definitely works. I was impressed with the display "example". It seemed sturdier than cans of Great Stuff. After a month, the foam is starting to turn yellow and brittle, just like great stuff. So the display example is definitely not what you will get. Other than that, it does what it's supposed to.

Bought five cans. Each performed worse than the previous until I got to the forth can. Spout broke off in the can a spewed foam everywhere. Great Stuff NEVER has done this. The photo only captures a fraction of the mess this junk made!

This is the second time I have bought this product and the cap brakes off, which makes it worthless. Get the original it saves you money in the long run

I bought this to fill the rim joist in my basement where I had some gaps and holes that I suspected mice were using to enter my house. This product was worked great to fill that entire area! It was easy to apply even in that tight space. The white color of the foam was a nice addition compared to the yellow foams that I've used in the past.

Perfect fill and cleaned up easy with nail polish removal. Going to try wire brush to remove from brick.

Definitely has a much more consistent texture than great stuff with few voids in cured foam. You can really see the difference when you trim excess foam. Appears also to be "stickier" against surfaces making it easier to use on overhead surfaces with less dripping and foam falling down before curing. The dense texture means it doesn't cover as much area as an equivalent size can of great stuff but this is to be expected and is worth the difference. The only reason for the 4 star rating rather than 5 stars is the higher cost per can. I will be using this product in the future.

[This review was collected as part of a promotion.] Loctite Foam works extremely well to fill large cracks and defects. I used the product to fill gaps between my shower door framing and the tile base. I was working with uneven Mexican tile that contained holes and gaps. Applying Loctite was fairly simple yet you should surround the areas requiring foam with drop cloths. Clean-up was simple and easy. This product is great filling small spaces and narrow angles. It is very important that you clean the applicator after each use to maintain its optimal performance and preventing clogs when laying foam around corners and edges. I’ve also used Loctitie to fill in broken floor tiles. Just remember to apply the product slowly to ensure even application. This is an excellent product that will deliver performance with ceramic or metal bases.

[This review was collected as part of a promotion.] This is a wonderful product! The Loctite Tite Foam for gaps and cracks is exactly that. Our home’s foundation is pier and beam. During the winter months, cold air seeps in from underneath our home, especially with strong wind gusts, which we have been experiencing a lot of this winter. During a break is this cold weather (temperatures actually inched toward the 60-degree mark), my husband crawled under the house to fill some of the gaps that were allowing the air up in the house. He was pleasantly surprised by how easy it is to use the product. The instructions were simple. The nozzle worked perfectly, very easy to get into the spaces that needed to be filled. The foam expanded and set-up quickly. And, in this case, no clean-up was required. He took pictures of his work so I could post them. Unfortunately, since he was under the house and it was fairly dark, the pictures aren’t any good. We definitely recommend the Loctite Tite Foam for any of your sealant needs.

[This review was collected as part of a promotion.] Recommended Product This does a nice job of sealing with foam that is definitely denser than other products I've used .A little goes a long way. That's what I realized yesterday after I used it to fill in some gaps between some studs in my basement. This product will continue to EXPAND OVER THE COURSE OF SETTING UP .. However , it was not a big deal as I was able to easily cut away the excess after it had dried with my sharp knife . Now , I'm left with a nice , tight , dense filled in area that otherwise is normally EXTREMELY difficult to insulate .You can use this around electrical conduit, plumbing , outside foundation cracks etc.

Really impressed with this product as it does exactly what the video shows, makes a very dense and flexible (but not compressible) seal. Been using GS for a long time, like most, and tried this out of curiosity as I had a lot of stuff to do and loved the result as it addressed one of the biggest problems I have with GS: When I have to trim it back, there are are always big pockets of air (some that go almost through the gap I'm filling) and that hard surface is nothing like the soft, more crumbly material you get underneith. This was surprisingly dense when cut through, with no big air pockets, and remained much more firm. I'm now using this exclusively for it's standard gaps and windows and door low expanding use. Still using GS for floor penetration and other "orange" fire rated foam required use (when I don't use fire caulk/putty).