Customer Reviews for Milwaukee 1-1/8 in. Hole Dozer Carbide Hole Saw

It is a 4" hole saw. It cuts 4" holes. DERPY DERP

Worked like a charm cutting through 2x10 with hole saw for bathroom fan exhaust pipe. Simple and fast to use.

Best hole saw kit I’ve ever used!

Very dourabl,,, I drilled 4 holes though drilling pipe for horse gates!! Very nicely

It met my expectations, because it did the job. But if you don't have a drill press or a very heavy duty hand drill and the ability to put your piece of work in a vice, be prepared to take a small beating. This hole saw will "catch" and want to twist your arm off. A small drill will simply not take the punishment if you have multiple holes to drill (I was making a wine rake in red oak and had 15 holes to drill). Worked great in my drill press or when I used my heavy duty hammer drill and vice in non-hammer mode. When I tried to use my regular DeWalt electric (corded) drill, it liked to beat me to death. And I was only drill partial holes.

...already make use of the Milwaukee Hole Dozer set...great product; but needed to make some larger cuts to pull the ceiling light fixtures through the drop ceiling planks...precise cuts quick and easy to connect or disconnect.

Great for wiring pass-through in shelving. Bought this to run wires in our new built-in cabinets. This hole saw worked great with my cordless drill to allow me to route the various power and signal wires to the shelves / cabinets below where all the different components sit. The 2" cable sleeves (also bought at HD) fit right in and give a clean appearance on top where the TV sits.

The hole saw did what it was designed for I bored 10 holes in 3\4 thick cast iron plates with only one hole saw I completed the job under the estimated time which equals profit They are good for those who know feeds and speed run them a slow rpm and they will last many jobs down the road

This hole saw is is rugged and sharp and just the tool you need for non destructive removal of plywood sub-floor from a concrete slab which I needed to do so I could get at a leaky water pipe under my dining room floor. I've enclosed pictures of the process using the Milwaukee 3/4" hole saw.

Need to cut a perfect circle? Nab one of these. I used it to cut a hole in our front siding for an exterior light. Made the job easy. Home Improvement 101- get one of these. You may not need them on a daily basis but when you do, can't beat it.

It worked perfectly. I updated several old desk in my office and at home by drilling holes in the desk top for computer cables,speakers, calculators,printers etc. Even as a beginner it is almost perfect .Thanks Brian

I needed to drill a perfect hole into my stainless steel sink, without scratching or warping it. I did some research on youtube and saw that everyone was using this BI-METAL HOLE SAW. I went a step further and stuck down some blue painters tape to protect the stainless steel sink before drilling. This worked perfectly and also took the shards and shavings away as I pealed it off. I used some 3-IN-1 oil to lube the saw and started to drill. Within 30 seconds I cleanly punched through my sink. THIS TOOL MADE ALL THE DIFFERENCE! If you need a tough bit to puncture steel, this is it!

Cut 2 holes and then burned holes

Solid hole saw and quick service!

works like a charm - had to cut a hole to accommodate a pvc coupling - this was perfect, cut clean and easily

It serve its purpose

It was as it was advertised.

I needed a saw that would cut through a plow frame so I could install a different set of lights. This saw made it easy to accomplish that.

Bad product, I was only able to do one hole, for the price I would not recommend it.

George was out the door within a couple mins. Got all but one item. There was only one available so it was a toss up.