Customer Reviews for Milwaukee 1/2 in. x 4 in. x 6 in. SHOCKWAVE Carbide Multi-Material Drill Bit

Did the job well. But showing signs of tip blunting after just 1 day

Drilled 7 3" holes in a concrete step - barely burned my way through the 8th and the bit was toast.

Went thru the stucco like butter very nice!

The bit held tight to the tapcon while drilling through thick concrete. The length of the bit allowed the drill to fully stabilize and grip the bit.

Worked well against brass shower fixture.

Worked well against brass shower fixtures.

Easy to use and makes the drilling in hard concrete easy

Did not drill well and wore out too quickly

Nice drill bit works great!

Not bad, it didn't break during a heavy use day, but flexes too much. It will break sooner than later.

This bit drilled into my concrete like butter. I only needed to make two holes for my project so I can't speak to longevity, but served my purpose well.

only used once so far.. did the job :o)

Using on brick mortar, only lasted 15 minutes before it became dull and useless

Broke two of these going through wood and concrete with a hammer drill. Obvious signs it got too hot and broke. Only lasted for about 5 drills tops.

Hace el trabajo y lo hace bien

Worked well for my need, I used this bit to drill holes in concrete to place anchoring screws in place for a gazebo. Happy with the performance. I did have to remove much of the debris from hole after drilling in order for anchoring screws to drill in fully, but that's expected.

Works better than expected. Drills like butter

Works great with my makita