No Results Found

Refine by Rating

Customer Images (1)
  • These didn’t work. I ended up cutting a slot in...
  • July 16, 2019

These didn’t work. I ended up cutting a slot in the screw head with my Dremel and turned them out with a flat screwdriver.

5 out of 5 people found this helpful
more details...
  • Didn't work...
  • October 29, 2019

Didn't work

CliffSpliff

2 out of 2 people found this helpful
more details...
By: CliffSpliff
  • I followed the directions to a tee and wasn't able to remove a single damaged screw.
  • October 30, 2019

I followed the directions to a tee and wasn't able to remove a single damaged screw.

  • DIY

JB

55 to 64, Male
2 out of 2 people found this helpful
more details...
By: JB
  • Used this extractor for the first time after purchasing it in 2016. Drill shaft was too short for...
  • February 23, 2019

Used this extractor for the first time after purchasing it in 2016. Drill shaft was too short for a screw with a recess hex drive which are commonly found with knock-down furniture (ie. IKEA) so I used a standard drill bit of the same size. Running my drill as slowly as possible in reverse, I still wore down the raised spiral material on the extractor side. Since I still might need a screw extractor in my tool box, I purchased the SPEEDOUT COBALT 10X model that is suppose to last longer at $19.97. I'll find out if it is any better than the SPEEDOUT TITANIUM 4X when I need to use it. Good luck to all!

arno

2 out of 2 people found this helpful
more details...
By: arno
  • I bought this kit after watching a couple on-line videos...
  • May 07, 2019

I bought this kit after watching a couple on-line videos that used the tool with success. One big difference between their application and mine: they were drilling down, I was drilling horizontally. They did not work AT ALL for me. Maybe when you can put your weight on it, it works, but that's not always possible. I'm returning them--very dissatisfied.

Vincent

2 out of 2 people found this helpful
more details...
By: Vincent
  • waste of time, didn't work at all...
  • October 22, 2019

waste of time, didn't work at all

HomeDepotCustomer

2 out of 2 people found this helpful
more details...
By: HomeDepotCustomer
  • Did not work at all as expected. Unable to remove...
  • October 29, 2019

Did not work at all as expected. Unable to remove the stripped screw I was working on.

Blake

2 out of 2 people found this helpful
more details...
By: Blake
  • Did not work at all..
  • October 30, 2019

Did not work at all..

DTCRUZNYPD

2 out of 2 people found this helpful
more details...
By: DTCRUZNYPD
  • Extractor could not penetrate the steel screw head and were...
  • October 15, 2019

Extractor could not penetrate the steel screw head and were therefore returned. Resorted to drilling out screw with existing drill bits. Surprised as I had used other extractors years ago and worked great.

HomeDepotCustomer

2 out of 2 people found this helpful
more details...
By: HomeDepotCustomer
  • Did not work for the screw I needed to take...
  • November 12, 2019

Did not work for the screw I needed to take out. I tried all 4 ezyouts but none worked.

HomeDepotCustomer

2 out of 2 people found this helpful
more details...
By: HomeDepotCustomer