Customer Reviews for Ply-Bead Plywood Siding Plybead Panel (Nominal: 11/32 in. x 4 ft. x 8 ft. ; Actual: 0.313 in. x 48 in. x 96 in. )

I did see that staining was not recommended but I decided to condition it and try and stain and it turned out great and the customer loved it.

Many of them had imperfections/cracks and I was unable to return it due to the size

I was looking for a more cost friendly alternative for part of our tiki bar wall and this worked perfectly! I used a few coats of pecan stain on it.

I used this product to make bead board doors for an antique-style cabinet housing a Murphy Bed. This saved a lot versus using bead board millwork. For my project I was able to make the lid and two doors from a single sheet. It was important to prime both sides of the panel; before priming the back there was a plywood scent inside the cabinet that priming eliminated. You can see more about this cabinet and bed here: https://youtu.be/Zug7zfoqyOs

Put this up on my shed on a Saturday and it rained for 2 hours during the night. Woke up Sunday to 8 pieces being completely warped.

These plybead plywood are very fragile. Time will tell of the duration

We have purchased this three times for a basement remodel, bought more today the they have cheapened the boards, thinner, awful edges, below you can see the old on the left and the new boards on the right. Absolutely poor quality. Not lowering price of course.

I love the way this plywood makes my porch looks. It is beautiful and makes it look like it was done by an architecture. It gives my ceiling a really nice finish.

One half warps so you wont believe it. At the price I would expect better.

Sturdy, easy to cut and install.

Easy to assemble. Nice option instead of drywall. Easy to install, but max height is only 8ft. Our ceilings are 9ft.

This is a great product for updating a room. Easy to install with a air nail gun or finishing nails. I used it to enhance the appearance and durability of my garage. I cut the panels in half (4') length, as that is the part of the wall that gets the most abuse. I will add a trim piece to the top and base board at the bottom. Can be stained and or painted. I'm painting a medium gray, the whole garage will get a new painting.

It served the purpose I needed it for and was very easy to cut and install.

great product, cuts and goes up easy, nice seams, used for a replacement wall in our closet, just need to stain it now

A great product I used for covering up entryway walls with remaining glue from which I’d removed old plastic tiles.

Great for the ceiling of my new patio deck. Much lighter weight than most beadboard and easier to install.

We looked at this in the store but needed many other items so we added it to our on-line order. I was a little afraid to order it like that because what we saw in the store was dirty, split, chipped, etc. But when we picked up the order all the pieces were clean and in good condition. It looks great on the wall and is going up well. We have had it less than a month still installing it. The only negative is that I found the same product locally for $4+ cheaper per sheet and would not have had to drive 60 miles one way to get it.

Not the best material I’ve worked with

Absolutely beautiful wood even painted. Can be used for practically any wall or outside framing and look beautiful.

Pick each sheet out carefully because there are a lot of damaged ones. I have installed this beadboard on walls and ceilings. I always use 16 ga. Pasload nails, fired at an angle, so they won't come out. After painting, the walls and ceiling look far better than they did when we started!

worked great for wainscoting and total wall...I used it for both in my home ..painted and stained

I knew that the wood wouldn't have to be perfectly matched because of height and location. I do wish that I had set aside the time to really pick through the pieces. The joints are a little sloppy so install techniques took a little fussing and tweaking. In this case because I was installing overhead, I testing my pieces in a run before tacking up. Be prepared to sand and put your gloves in your pocket before your trip to your favorite HD!

It looks very good on our decks under roof . can't wait to paint it.

All pieces had black mold on them.

Awesome and the employee went out of his way to load it for me. Thx sooo much??

Not a perfect fit but good enough.