Customer Reviews for Sanded Plywood (FSC Certified) (Common: 23/32 in. x 4 ft. x 8 ft.; Actual: 0.703 in. x 48 in. x 96 in.)

It's wood. Did what it's supposed to do.

Adequate, but for the over $50 cost, lower than expected quality that required some fill & sand on the "good" face.

This is worthless. It is FULL of voids…which you don’t realize until you have started cutting. Although >$50 is not cheap….spend more money and avoid the voids!

This plywood works great! Thanku!

I like the wood but Someone tried to mend a couple places on the wood with puddy. I didnt notice it until after i cut the wood and began sanding, at that the putty popped out. The project worked out ok tho.

Exactly what I needed and expected. Cut the sheet in 1/2 and used it to mount a tankless water heater. Painted up perfectly and was exactly what was needed. Only complaint the price, $$$$$, but that seems to be everything anymore.

The staff is just wonderful at Home Depot. I hope they are rewarded and the job is worth their efforts.

The plywood was used to create carriage doors for my garage. I used the sanded side to face the outside and used pine 1x6 boards to dress it up. I finished it with an outdoor rated poly. Overall, very satisfied with the product.

Great people helped me there

This plywood was perfect for the base platform of my new HVAC system installed in my attic. It was thick enough to the job, but not too pricey. I also bought enough to place up in my attic for future walking plank purposes.

Sanded sand looked nice . BUT found veneer peeled away on corners because of lack of glue. Will look a lot harder on next purchase. Feel it was a bit overpriced for the quality.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Good for the price, but there are a lot of plugs in the sanded side, and there are also a good deal of voids in the layers.

Delivered in fairly decent shape. Plywood has voids and was bowed - not flat. Worked ok for My project.

This "sanded" plywood is better than your common sheeting, but definitely not what I was looking for for shelving. It was, however, good enough for my workbench. If you have low standards, this should do the trick.

Wood was warped should have looked closer all three pieces.

Semi sanded on one side/smoothed on the other,light sanding on rougher side will give same effect for viewing from both sides

This Plywood has one nice face, very few voids, but it is far from flat! I picked the ones I could find in the store, but I am using it for shelves and they should not have a sag before they are loaded! Was going to use some of them for cabinet doors, but they are just too warped.

Perfect for my purposes.

I was very disappointed in the overall quality of the plywood. It wasn't a cheap piece although it wasn't cabinet grade. However, I had to modify the construction of my project to accommodate the poor quality.

Rating provided by a verified purchaser

Great piece of wood

It’s a very bad quality. It’s warping so bad.

Rating provided by a verified purchaser

I used three of these plywood sheets to help build a 2x4basics.com workbench. Over all the sheets I selected were good. I'm surprised that Home Depot puts a few substandard sheets into the inventory bins. Of course you can select ones you buy, it just seems that bad boards should not even be put on the floor.