Customer Reviews for SharkBite 3/4 in. x 300 ft. Coil Blue PEX-B Pipe

This stuff is great, easier and cheaper than copper!

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Normally 3/8 in. PEX pipe is available in 5 ft. and sometimes rarely 10 ft. in store. In my project I do need much longer to carry hot water. This product is 50 ft. which is long enough for me so no pipe coupling anymore.

It's PEX pipe and it's straight, no need to fight the curve from the longer rolls of pipe. Wish HD actually carried this in the stores instead of online ordering only

Worked as expected! Perfect!

Worked out OK. Roll was difficult to unwind to say the least. Took 3 of us. Nice product and meets Orange County FL Code. After laying in trench, it was great. Still have to have it connected to water meter and have inspected by county. Will let you know.

Good stuff. Easy to work with, goes around curves, tough as nails and a pretty good value. Fitting easy to install, quick crimp and you are dine. No leaks.

I purchased 2 300 Ft. packages but was shorted a hundred feet, so paying plumber extra money for the 100 feet that we’re misting

Great price and fast shipping!

Ready pipe to work with. Easy to find fittings and tools to work it.

I get about 2.2 gallons per minute at 50 feet of pipe which is more than enough for any faucet. It cut wait time down from 40 seconds (with 1/2" pipe) to about 10 seconds. Its a big difference.

I use 3/8 for high flow faucets like bath tubs and I use 1/4" for faucets. With 3/8" pex I get a flow rate of 3.5 gallons per minute at 50 feet of pipe.

Product was shipped promptly and in great condition. The coil was hard to get straightened out and had to be stretched for a while to keep it from coiling back up.

Worked great, was able to straighten it out fairly quickly and easy. Fittings fit on it good.

Rating provided by a verified purchaser

I would have been good enough with a 100' roll but it's cheap enough I got the 300' to make sure I didn't come up short, and I didn't. Great stuff to work with for an easy install. Takes a little while to get the bend out of it from being rolled up tight so unroll the length you need early to make pulling it through easier later.