Customer Reviews for Tapcon 3/16 in. x 1-3/4 in. Phillips-Flat-Head Concrete Anchors (75-Pack)

Awesome

Really good and easy to install in a concrete wall

Several of the screws in the package were defective and had to be discarded. Several of the screws had heads that were filled with metal, making it impossible to get the bit inside the head.

The screws work really well. The drill bit doesn't last too long when drilling into HARD concrete. I would get one drill bit for every 10-15 screws. Also, the drill motor used is important. If the bearings are loose or the bit wobbles, it can cause the hole to be JUST a little to wide. This causes the screw to strip the concrete. If this happens, I add a wood wedge.

Easy to use and held tight with anchoring the handrail in the masonry block

Just what I needed. Mounting a mantel on a fire place. Drilled six holes put in six screws in the mounting board. Mounted the Mantel. Customer said I made look easy. It is easy when you have the correct screws.

I attached several boxwood panels to a block wall using a combo hammer/rotary drill. The screws and the included drill bit worked very well and never gave me any problems. I used about 100 screws. I will be using again for various projects.

These were perfect ot sett the brackets for the 4x4 posts on a pergola...

Very resist head snaps without wear out the head after you put it in the concrete wall or floor. its cheap to buy the bulk box of head snaps rather than small quantity of head snaps. you can drill it in the wall then put the resist head snaps in without need to hire the contractor for any hard job. you can use for any projects in the future which you don't need to buy long lumber wood to connect between two studs. you can put it nowhere on the concrete to minimize the cost of materials.

Drill bits that were provided in the purchase are not useful. I bought a separate bit that provided cleaner holes for the screws to attach in.

These screws worked great for what we needed

They snap at center before they strip… and the heads are packed with the coating and not useable!

Rating provided by a verified purchaser

Very poor quality. Pilot holes more than deep enough. Just as they seat, they snap. This was on a toilet flange, definitely not going crazy tight.

I have been using TAPCON's for many years and they always perform excellent!

Performed as expected.

I wish they have the 3” instead of the 2 3/4 tapcon with countersink head!

These rap cons won’t con you they just do what they’re meant to do

Easy to order online. email when ready. picked up in pickup box. The price was good.

Rating provided by a verified purchaser

Only light torque required to break them or threads get worn off instantly. It's almost as if they were never heat treated. I tried some nearly identical screws from the local hardware store and they don't break. Don't waste your money on these.