Customer Reviews for bioBidet SlimEdge Non-Electric Bidet Attachment System in White

I got this through kick starter for $39 and I’m extremely pleased with the product. I’m so happy with it I now wish I had ordered three more for the rest of the house. I installed it myself this morning, it took me about half an hour. It works great. Much better than spending $2000 to $3000 on a new toilet with a bidet system built-in. I am definitely recommending this to my friends and family. If you can get by without the extra frills like a heated seat and heated hot water, etc. then this is the bidet product for you.

This works even with my RV toilet. I love the two settings for strong and gentle rinse. I would have never dreamed I could get this kind of luxury for my 5th wheel! I love this product and its adaptability. Works even in my small space!

Love this product. I grew up with a bidet in our bathroom, but haven’t seen many since we moved. So I was so happy to see this on investor site. And so easy to install took 10 minutes if that.

I use a Kohler toilet seat and its contours caused the back of the seat to touch the bidet first. This in turn lifted the front of the toilet seat off of the bowl. The solution was to use a flat bottomed toilet seat.

I just got this last week. I wanted to to install it immediately, so I started before I had to go to work, and had it installed in about 15 minutes. You can probably install it faster if you first get the right sized Allen wrench for your toilet seat lol. It is so easy to use, however I recommend that you sit down before you test it, unless you're looking to wash the opposite wall. It is not intrusive and it's a very short learning curve in that I figured out to turn it slowly and about where I like it strength-wise in a couple of uses. Amazing! So much cleaner than toilet paper. I suggest if you're not able to get a full bidet, get this. Love mine!

Installation was simple and the arm for controls doesn't take up a lot of space in my space lacking bathroom. Being first time users of a bidet my girlfriend and I were a bit timid at first but after using it the fear quickly subsided. I don't know who the maxed out setting is for but if power/pressure is a worry you shouldn't fear as this little guy will do the job. The controls are simple and intuitive so when someone gives it a trial run they should pick up on it immediately. I wanted a bidet to cut down on wet wipes and toilet paper and also hoping it would leave us feeling cleaner. If those are your reasons also I would suggest checking this out. I am sold on the idea of a bidet life now and I think an upgrade will happen down the line to a more complete setup.

It's 100% effective, and I use almost no toilet paper now (2-3 squares on the water to prevent splashing, then a little to dry off after using the bidet). I think it looks much better than any other bidet attachment available. The type that's built into the seat looks slightly nicer in my opinion, just due to the fact that the contours around the back of the seat are simpler, making that area easier to clean, but they're not worth the $200-300 they cost. For the type of bidet attachment which this is, this seems to be the best one available. It's also an amazing deal for $35 (which is what I paid at the time I bought it, just in case this is being read later at a different price). This is my first time using a seat attachment like this, so I'm not sure if the way the water spreads is normal, but the way it sprays is a little like putting one's thumb over the end of a garden hose. That's not a problem, but it was a little unexpected. I will say that it in order for it to actually clean effectively, it does need to be a little forceful. So for anyone new to bidets, keep that in mind. Again, I'm not saying that's a problem, but one should know what to expect. It's very easy to install. It doesn't seem to significantly effect the angle of the toilet seat, which a lot of reviews mention about other bidet attachments. It's really slim. I would recommend this exact product to almost everyone who's looking for a bidet attachment.

We installed our bioBidet today and it is great. We are going to order another now for our other toilet. Great value and product. Highly recommended.

This product is brilliant! I have a home healthcare business and hygiene is very important to me. All of my clients are sold on this product and desire to buy one for themselves. Easy to install and visually appealing. Buy a bioBidet! #Save Tree's!

I just installed this by myself. It’s a little bit of juggling but I doubt there is enough room for 2 people to maneuver around the average toilet. I installed this in my auxiliary bathroom for guests and myself. Important to get the connections tight, use the tape it helps a lot. The instructions are not so straight forward though. The clear rubber baskets set into the grooves on the back of the unit and the round adjustment panels sit inside the round holes on the front of the unit. 4 stars because well, it’s not a fully function8ng heated seat and water with massage function, but it’s easy, simple and economical for a guest bath.

Universal fit for every toilet shape. Easy to assemble, with good quality hose and fittings. Have had for a few months and is working perfect.

This is one of the most useful devices in the home. It helps to clean yourself better than before. It even helps when it is difficult to go! I even wish they had one at work! Cost was great and well worth the money!!!!!!

I bought this product 2 months ago but installed it about 2 weeks ago. I love it so far. It’s slim design keeps the seat sit on the bowl properly. The knob is at a very convenient position. I am happy with the product.

So easy to install that even I did it! Works just like they say and is so thin there is no notice of it. Vary happy with this purchase.

Exceedingly simple to install, with aim that is true. I purchased this specifically for it's minimalist appearance. Dare I say elegant in appearance? yes, I do!!

I bought my bidet directly from the biobidet website and it arrived in no time! It was easy to install (minus the mishap where my husband took over and lost the rubber washer & it started leaking despite the water valve being turned off). It works well and has a strong spray. My husband and I are happy with our purchase.

Beautiful design and high quality bidet. Very easy to install.

The attachment was easy to install and completed in less than 10 minutes as the instruction are very clear. The product functions as advertised and exceeded my expectations. I am ordering couple more for my other toilets at home. Definitely recommend it.

A very simple and effective Bidet. Uses only water pressure to deliver cleaning power. The knob is a bit touchy and is controlled by gently turning the knob slowly toward the cleaning direction you desire. Right for the female front side and Left the rear side. Slight movement for low pressure wash and full quarter turn to the symbols for FULL Pressure wash. Water will be "room temperature cold." Installation is straight forward. If you have done any type of plumbing than you can finish this install in under 10 minutes Only thing 2 that are concerning are 1) mostly made of flimsy plastic and I am afraid one of the kids might accidental lean too much on the dial and "snap" water spraying everywhere. which comes to the most problematic issue. 2) No quick disconnect/water shutoff in case the tubing breaks or the Bidet otherwise cracks or breaks in any fashion you will have water everywhere. but I guess it is no worse than a busted/leaking supply hose.

Slim Edge Non-Electric Bidet Attachment System in White is very easy to install. I ran up on a old supply valve that did not want to turn off, but my home is 33 years old. To install you disconnect the supply to the tank not to the wall and insert a heavy duty fitting that feeds the bidet. It has two streams one for the ladies and one for everybody. They use silicone inserts to keep it from sliding and they work. I had never used one so it's a little shocking at first, it's growing on me. I think I will want a mixer valve installed by winter to make the water tepid as it is in the summer. I use much less toilet paper and that is nice. You feel cleaner. I had a grandchild enjoy themselves wetting everything. I have a spray bottle and I think I will put a longer hose on the shower head to make it a cleaning tool. In the photos I show it attached to a new tank valve so you can see how it hooks up. Everyone will love this..

Lets just say ... so easy to install. Instead of having to attached at the value portion this version's T-Adapter actually installs on the toilets junction. So much easier to install than others I have installed in the past for friends and family, 25 min which included about 10 min of OCD QC time which plumbing and electrical usually take. The installation is so easy I was able to go it with minimal tools, wrench, and a little plumbers tape. So lets just say it was a shocker to use the first ... I was shocked but as I have continued to use it made me feel cleaner than normal TP wiping. It was so shocking that my wife screamed and then laughed uncontrollably when she first tried it. So be warned. The only complaint ... it makes the toilet seat feel a little flimsy because it raises the seat about a 1/8".

Fits my low flow Kohler toilet and sprays where it should. No potty humor review. The install instructions are rather straight forward. They take their time and go into detail. So if you have replaced a toilet seat, you can do this install. I was concerned this wouldn't fit my Kohler because it has an angled lip at the back. The install took me all of 5 minutes. The bidet seems to be made of quality plastics. It has some weight to it, so I am sure it uses metal inside. As for the um functionality. It has 2 settings and 2 sprayers. One for female cleaning and one for 'posterior' cleaning. The valve is touchy, it goes from nothing to "oh my" to "power washer" in a few small clicks. Thats probably a good thing given this is not an electric model. The water is going to be cold water faucet temp. So if you live in the north on a well, this might not be the bidet for you. If you live in Texas or the south like I do, where the water is 75 degrees in the summer, its no problem. Its still a surprise, but at least its not ice water. Why did I drop a star? A few small items bother me. It props the lid upwards a bit when the seat is closed. This means its not completely closed lid. I'd like the hose to have organization clips so I can tuck it out of the way. The side part bounces easily, thats a bit concerning given its holding pressurized water. But overall, I like it. It reduces my TP usage. I usually just need a bit to 'dry up' after use.

This bioBidet is a good alternative for the more expensive units. It works on any shape toilet. This one is a round front style. There is no electric connection and is an easy DIY installation. Everything was included for installation, except that I needed longer seat bolts. Luckily, there was a spare new set from another seat that I saved. Installation was pretty easy. Not too many parts. The water connections were made. Then just a couple of parts on the bidet unit and attach under the toilet seat. It is simple to operate. There are three positions on the control knob. Off, left toward the back clean, and right for the front clean. The water pressure can be adjusted for either position. You still need your toilet paper or towel as there is no dryer with this type of bidet.

Really easy installation, with no leaks! Plenty of water and pressure leaves one feeling clean.

Works great. Easy to install and I love the brass fittings instead of plastic.

The stream fans out a bit. I'd prefer more accuracy.

Almost perfect. The back plate that attaches to the toilet seat sticks out too far because its square. If it were round it would align more with the profile of most toilets.

Plumbing equipment not required, but a regular pliar helps. Use the teflon tape where ever you attach, reattach anything that connects. Like magic, tight, no leaks. 30 minutes and ready to use it. Our toilet's tank valve was a bit tight to get at and even then, the whole thing took only a few minutes. Like others, I will say I do not mind the cooler water at all, no heat needed. I am so happy not to need electricity or any "plumbing" installs. Just unscrewing and rehooking up various pipe fittings that are provided is easy/breezy.