Rated 3.2 out of 5 by 11
Rated 1.0 out of 5.0 by Pelican Not good for exterior flat surface if left untreated.
Purchased April 12, 2016. Already delaminating. Cracks; Splits;.
May 17, 2016
Rated 4.0 out of 5.0 by kamcam vertical usage.
Purchase this product to replace rotten plywood on side of our home. After removing the rotted wood, then prepping area, found this product to be a much better alternative to what was removed. Cut easily, no need for pre-drilling. No warping, or seperating of layers. After caulking any small voids. Purchased the Behr brand flat exterior paint. Only took one coat and the results were amazing. Note: it IS really important to pick out the sheets yourself. If you spend the time to inspect each piece as there were some with large knots, small splits, etc... I would recommend this product if project is vertical installation.
May 16, 2015
Rated 1.0 out of 5.0 by Erik NOT a QUALITY product
Bought this product in June of 14' for an exterior project. By October 14' the plywood sheet lamination's were separating and peeling apart; they look terrible. Do not recommend this product. This has happened more than once before to me with the same Home Depot product
December 5, 2014
Rated 2.0 out of 5.0 by Verified Reviewer Quality varies
Thickness varied from the rated 15/32 to nearly 3/4 in. where the inner layers were being lapped at the factory. Too many voids on both sides of the plywood. I'm using it for roof sheathing on a temporary structure so the quality isn't important. I learned one lesson: if you have them deliver it instead of picking it out yourself at the store, you probably won't be happy with what you get. Next time, National Lumber gets my order.
September 1, 2014
Rated 5.0 out of 5.0 by Daniel Extremely satisfied!
I am using about two entire sheets of this for the flooring of a small temporary flooring setup that houses 150 pounds of weight in an area at any given moment, and has done up to 400 pounds for about 10 minutes. Granted it's sitting on some 2x4s for some support, it works much better than I expected! It's almost 7 months in of two and a half years expected of it, and with some water coming on a little part of the board when it rains (leaky area), temperatures varying up to 40 degrees daily, and a car battery dropped on it, it hasn't even warped a bit! It definitely exceeds my expectations, since I was a little afraid the wood may break within a few weeks or a month into the project given the conditions.
I'm going to use this same board for a little extra protection above my structure for some additional help with rain, and I can definitely trust it now! Thanks, Home Depot!
May 4, 2014
Rated 3.0 out of 5.0 by bk234MP1995 pressure treated lumber
The product was what I needed to complete the job.
October 21, 2014
Rated 5.0 out of 5.0 by csummers Good plywood
Good solid lumber for home projects. Holds stain well and does not warp.
May 14, 2014
Rated 2.0 out of 5.0 by jefro mixed quality surface sheeting
Since pressure-treatment adds to the cost of the plywood, better quality plywood would be reasonable as starting material. I'm not commenting on mere cosmetic flaws, but on substantial cracking, splitting, and unpatched voids. Why bother to pressure-treat poor quality plywood?
November 14, 2013