Rated 3.3 out of 5 by 31
Rated 1.0 out of 5.0 by Lucentray Bosch Diamond Grit T-Shart blade
This blade made a great cut for about 1.5" before it died. I regret purchasing this blade for a simple tile job.
June 28, 2016
Rated 5.0 out of 5.0 by SConnett Keep it cool and works perfectly
I researched this blade for a bit before purchasing. I thought I would try to method someone else posted, filling a bucket to top top with water, lay the tile on top of it letting the blade dip in the water constantly while cutting. Take your time, it will take a while, don't use heavy force to do the cut, it worked out perfectly for me. If I had to guess, all my cuts totaled up, I made around 3'-4' worth and the blade is not worn.
June 14, 2016
Rated 2.0 out of 5.0 by Colorado Works okay, if you're cutting 1 tile
Needed this piece to cut some faucet holes for tile we were installing in our shower. Worked great for 1 tile, then was so dull we burned out the motor on our saw trying to cut the other piece. Disappointing considering the price.
March 22, 2016
Rated 1.0 out of 5.0 by Mike Worthless
Used this to cut some backer board/hardi board. Got through 1 sheet (5 ft) and it was completely dull.
March 14, 2016
Rated 3.0 out of 5.0 by 2Cheap2PayApro 3 Stars for 3 feet
I used this to expand the opening for a cooktop in a Silestone countertop. I barely went 3 ft before all the abrasive was worn off the blade. You will need 3 to 4 of these to get a cooktop installed.
February 23, 2016
Rated 1.0 out of 5.0 by DIYRob Not for porcelain
I was only able to cut 2 inches into a porcelain tile using water and the diamond coating wore off. I applied slow steady pressure too. I think these blades are coated with tin foil; not diamond
July 24, 2013
Rated 5.0 out of 5.0 by Mike very pleased
Well constructed, cuts very smooth. I used it to cut 3/8 hardibacker board.I will buy again.
October 25, 2015
Rated 5.0 out of 5.0 by Kirk Worked Great
We are remodeling our guest bathroom and I bought this blade to make some difficult cuts in cement tile backer board. The blade made clean cuts very quickly and was a lot less expensive than a cement blade for a circular saw. Plus, I could make the round cuts for the small holes for the pipes and water valve. It worked so well that I started using it to make long straight cuts over the "score and snap" method. However, cutting with this blade created more dust than the snap and score method so I strongly suggest using a mask and maybe some sort of dust collection. It lasted through out my project without losing any performance.
August 26, 2014