Rated 3.2 out of 5 by 9
Rated 1.0 out of 5.0 by fred Dimensions Not as Adveritised
The box and the specs state that this arrestor will fit up to a 14" wide flue. It will not. My flue opening is 13-7/8" wide. The three bars for restraining the arrestor by tightening up against the inside of the flue only open up to 13-1/2". Thanks for wasting my time.
November 25, 2015
Rated 5.0 out of 5.0 by UltraR Both are good... the one in Stainless Steel comes with a Lifetime Warranty
I have bought both the Black Powder Coated CG3BLK and the identical more expensive CG3SS... both work well provided it is properly secured at time of install.
For extra money... the Stainless version is the one I buy because it has a lifetime warranty!
Can't go wrong with either and the beauty is either will fit just about any kind of masonry fireplace since it clamps from the inside of the flue as opposed to the outside like the competitors.
My only wish is that Home Depot would stock the Stainless CG3SS too!
July 11, 2015
Rated 1.0 out of 5.0 by Duck82 This is a horrific product that should not be sold!!!
Wing nuts strip out prior to being sufficiently tightened. Fully expect this to be blown off my roof in first storm... Keeping my receipt handy...
September 5, 2015
Rated 1.0 out of 5.0 by NGWebb The wind blew it off.
A week after installation, before a fire was even lit in the fireplace, the wind blew the spark arrestor off the chimney. It is lying on my roof where it landed. Will probably try to get someone to install it again.
Since someone else installed it, I don't know if the instructions were followed. Directions seemed to be easy and straight-forward.
March 31, 2015
Rated 4.0 out of 5.0 by ace1313 Nice product
It seemed it was easy to install and it was nicely constructed
April 7, 2015
Rated 4.0 out of 5.0 by Wiley300 Chimney Cap/ Spark Arrester
Very nice Chimney Cap/ Spark Arrester, very easy to install & was accually better then the one I was looking for. Thank You
February 23, 2015
Rated 5.0 out of 5.0 by polar Very Easy Install
A very easy installation of a chimney cap. It took about five minutes to do. Easily attaches to the inside of the flue.
August 12, 2014
Rated 5.0 out of 5.0 by BigMike Easy. to install.
Easy to install. No tools required. Except a ladder of course.
September 1, 2014